Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Union Graduate Part ii

Posts

Union Graduate Part ii

#1

Union Graduate Part ii

Mike D

>The lathe I am being offered is the bowl turning version. There is no bed or tailstock. The motor is wired for single phase 220v. It is rated at 1 hp. It is used in a school setting. Students are still using the lathe, but the school is upgrading to a Powermatic 4224. They want another lathe with a tailstock. They would include a Oneway chuck with the lathe. The price is sub $1000.

For a brand new turner who wants to focus on turning bowls, how important is having a tailstock? Is 1 hp enough power to turn up to 12" bowls? The speed range is 425-790-1330-2250. The weight without the tailstock is 325. Is this heavy enough?

Thanks for your advise!

Mike

Fairport, NY


img

Re: Union Graduate Part ii

#2

Re: Union Graduate Part ii

Sean Troy

>The slow speed is still pretty fast for roughing. You would most likly want 150 or even less for roughing depending on the blank. Having a tail stock can be a blessing. I think most would agree that waiting until you have the funds for lathe you don't have to compromise on is well worth the wait.

Re: Union Graduate Part ii

#3

Brad Vietje

Re: Union Graduate Part ii

Brad Vietje

>Mike,

I think for the best form and balance, a tailstock is very important -- I start all bowls between centers whenever possible so I can tilt it a little this way, or a little that way to make the best use of the wood. This is fairly important for a beginning bowl maker to learn, before so-so bowls become a habbit.

You may be able to get the other short bed that would bolt onto the opposite side, and get the tailstock assembly for it -- these aren't common, but you might find one. You could also get the entire long bed and tailstock assembly for this lathe, if you can find them.

Besides all that, $ 1000.00 with a Oneway chuck is a very reasonable price for this lathe if its in good shape -- you will just have to make decisions about exactly how the blank will be mounted before you begin turning. A friend recently sold one of these without a chuck for $ 1200. If you use good technique and sharp tools, 1 Hp will be sufficient, but you won't be hogging off 1" monster cuts with it.. I also agree with George, that slowing the motor for roughing would be best, but the motor cam always be replaced, possibly with a variable speed setup.

Good luck,

Brad Vietje

Newbury, VT