Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Danish oil finish problem

Posts

Danish oil finish problem

#1

Danish oil finish problem

Brad Bittle

>I turned a 10" cherry bowl last night from a dried rough. While mounted on the chuck(tenon), I wet sanded the inside of the bowl up to 1200 grit with Watco danish oil. I also saturated the outside of the bowl up to the unfinished tenon in the chuck. Tonight I reversed the bowl in my vacumn chuck and finished turning the foot. I then wet sanded the outside of the bowl as I did the inside. When I unmounted from the vacumn chuck, I found that I had a ring on the inside of the bowl due to the rubber gasket sealing with the oil and leaving a subtle stain or ring. It appears to go deep into the wood, and wet sanding from 400 to 1200 doesn't help. Any ideas as to how to remove the ring?

Re: Danish oil finish problem

#2

Re: Danish oil finish problem

Gil Jones on Lake Seminole GA.

>No, but soaking it in the same oil might help. Plus, while the vacuum chuck is a great tool, if the applied finish or oil is not fully cured (inside the wood), the vacuum is going to pull it back to the surface.