Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Question about multiple glue ups?

Posts

Question about multiple glue ups?

#1

Question about multiple glue ups?

Rory

>Greetings to all! I have been getting "Oak Stave's" from the local winery. This is the wood that has been in the oak barrels to add taste to the wine. You can tell if the staves have been in either white or red wine. real pretty in color and a slight purple tint, and great grain too. Anyhow, after putting them through the thickness planner and cutting to length, I glue them up. Oh yea, the stave's measure about 2 1/2" wide, 1/2" thick, and 36" long. Anyhow, I apply a thin layer of glue to both sides and put them into some pipe clamps. Here's the question, Do you need to apply moderate pressure, OR torque the heck out of the clamp? I have been putting the most pressure that I can apply, and I'm starting to get the threads alittle rounded over on the pipe clamp. So, is it moderate or as much pressure as possible? Another thing, I'm 6' and weigh 250#, so when I apply pressure, you can bet it is a LOT!!! I hope to soon show some turnings of the wood at a later date. Thanks

Re: Question about multiple glue ups?

#2

Re: Question about multiple glue ups?

Stuart Johnson

>Moderate pressue, just enough to get some glue squeeze out. When you really crank down you are weakening the final glue joint.

Re: Question about multiple glue ups?

#3

Re: Question about multiple glue ups?

Jake Niedling

>Rory - are you glueing up with bevel edges or straight. If you are using the bevel edges ( staves ), then usually what I do is hold two pieces together by hand until the glue gets tacky enough to hold it by itself. Once the glue is dry, then glue the two's into fours, etc. For straight edges, I would only use moderate pressure, I think too much pressure can squeeze out too much glue and leave a weaker joint. I am not the glue master, but this has worked for me.

Re: Question about multiple glue ups?

#4

Re: Question about multiple glue ups?

Rory

>Thanks guys, you have probably saved my clamps. After the staves go through the thickness planner the are pretty much equal in thickness. What I have been doing is gluing them up to about 7 at a time. This is the width of the boards. Then I glue them up into a square block, alternating the grains. Have not turned yet, But will post after turning one. Thanks

Re: Question about multiple glue ups?

#5

Re: Question about multiple glue ups?

John Scheideman

>Modern glues are stronger than the wood itself. If you apply too much pressure you will squeeze out too much glue, leaving a weakened joint.

Re: Question about multiple glue ups?

#6

Re: Question about multiple glue ups?

Russell L. Babbitt Jr.

>Yup like everyone says moderate pressure. Before gluing you need a good dry fit and then apply glue and then moderate pressure. Don't use clamps to pull boards together. They are just there to hold the boards together while the glue sets.