Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Another Powermatic Question(s)

Posts

Another Powermatic Question(s)

#1

Another Powermatic Question(s)

Clem Wixted

>I had a machine shop cut a few pieces of 1 inch cold rolled steel to be used as posts for some shop made tool rests.

The 1 inch doesn't fit into the banjo. It is a tad large.

Two part question:

1. Is the hole in the banjo a metric size?

2. Can I ream out the banjo to receive the 1 inch crs?

Thanks,

Clem

Re: Another Powermatic Question(s)

#2

Re: Another Powermatic Question(s)

john lucas

>Clem I think the Cold roll is your problem. I wouldn't ream the hole, I'd shrink the bar. I had the same thing happen with cold roll. Then I bought some 1" drill rod and it fits perfectly. You might try sanding it a little. If you have a chuck you can chuck it up and sand one end, then reverse it and sand the other. It shouldn't take much. The hole on my banjo measures exactly 1". The factory tool posts are about .002 under 1 inch.

Re: Another Powermatic Question(s)

#3

Re: Another Powermatic Question(s)

Gary in Zirconia, NC

>1" cold rolled fits in my 3520a very well.

Re: Another Powermatic Question(s)

#4

Re: Another Powermatic Question(s)

robo hippy

>I seem to have that problem off and on. One of the Oneway rests (made before they shortened the post) just barely fits. I had a friend make me some rests from cold rolled (5 of them), and one does not fit. I had the old rest for the 3520 A, and there were no problems with it. Go figure.

robo hippy

Re: Another Powermatic Question(s)

#5

I did some re-checking and...

Clem Wixted

>...found that the 1 inch crs does fit. The pieces I tried to slip into the banjo had a burr from the cutting hacksaw. When I cleaned this off it fit very well.

I also had a piece that I think may be hot rolled. It has a different surface than the crs and was a little egg shaped. I mic'ed it and it was almost 8 thousandths long and about 4 thou short, creating the egg shape.

The hole in the banjo was .9995 inches, according to my digital micrometer. The crs measured .995".

Thanks for the input.

Clem