Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Odd web behavior - Industrial Supply sites.

Posts

Odd web behavior - Industrial Supply sites.

#1

Odd web behavior - Industrial Supply sites.

Craig Daymon

>I was reading (and printing) the recent posts by Molly Winton and Barbara Gill about home-made burners and thought I'd search the industrial supply sites for parts (maybe a phenolic barrier strip?) and Enco was unavailable, MSC Direct was unavailable and McMaster-Carr was unavailable. One site I can understand, but 3?

Anyone else seeing this?

-Craig

Re: Odd web behavior - Industrial Supply sites.

#2

Re: Odd web behavior - Industrial Supply sites.

Gil Jones on Lake Seminole GA.

>Enco is still down at 1057pm EST.

Re: Odd web behavior - Industrial Supply sites.

#3

Re: Odd web behavior - Industrial Supply sites.

Mark Mandell - Gone Round In Jersey

>Mc Master's up, so is Grainger

Re: Odd web behavior - Industrial Supply sites.

#4

Re: Odd web behavior - Industrial Supply sites.

Craig Daymon

>Grainger did seem to be up and McMaster came back after a bit. I don't know if MSC Direct is back yet.

Thanks for checking.

-Craig

Re: Odd web behavior - Industrial Supply sites.

#5

Re: Odd web behavior - Industrial Supply sites.

john lucas

>Craig The connectors that Molly was using are sold at Radio Shack. I don't remember what they are called however. I'd have to go by the store. Most electronic stores have other connectors that would probably work. The advantage of the connectors that Molly used, are they can be dissassembled so you only have the metal parts. These can then be glued into a pen blank. leaving one of the screw in surfaces outside.

Re: Odd web behavior - Industrial Supply sites.

#6

Radio Shack Barrier Strips

Barbara Gill, Remlik VA

>They are Radio Shack part# 274-677 12 Position Barrier Strip European-style design

Re: Odd web behavior - Industrial Supply sites.

#7

Re: Odd web behavior - Industrial Supply sites.

Bob Fawcett

>reidsupply.com is another good site. They give excellent service also.

Another possibility is an old ceramic tube socket. The small ones could be broken or cut to leave only 2 connectors. The pins on small tubes may be the same size as the nichrome wire and you would have a push in connector. Just a thought.

Re: Odd web behavior - Industrial Supply sites.

#8

Re: Radio Shack Barrier Strips

Gil Jones on Lake Seminole GA.

>Barbara, you answered my (chat) question. 274-677 is the 10-amp version. Radio Shack also has two 30-amp versions (274-679 and 274-680) that 'look' about the same as 274-677. I was thinking that the 30-amp terminal block might be made to take more heat (or not). A trip to town will answer that question.

Thanks

Re: Odd web behavior - Industrial Supply sites.

#9

Re: Radio Shack Barrier Strips

Barbara Gill, Remlik VA

>Carole and I were lucky to get what we did given the expertise of those Radio Shack guys out on West Market St in Greensboro NC. One was totally clueless; the other at least found what we were looking for from the description which was a pretty good one.

They had some heavier ones but they did not look the same as the one Molly had.

Re: Odd web behavior - Industrial Supply sites.

#10

See post below about McMaster and barrier strips

Craig Daymon

>John,

I think what Barb bought at Radio Shack and what is available from McMaster-Carr (and probably every other industrial supply house) are the same thing. The McMaster-Carr page gives a very detailed description of the products. They also have the phenolic versions, which can handle about 70 degrees (Farenheit) more heat. McMaster-Carr calls them "Terminal Blocks", but states in the description that they are "also known as barrier terminal strips".

McMaster-Carr also sells nichrome wire in a wide range of diameters.

See my post below in Barb's thread for the catalog pages at the McMaster-Carr site.

-Craig

Re: Odd web behavior - Industrial Supply sites.

#11

Re: Radio Shack Barrier Strips

Gil Jones on Lake Seminole GA.

>Barbara, going by my NiChrome amps/temp chart, it takes a tad less than 10 amps to heat .020" (24 gauge) NiCh wire to 2000� F, and I doubt that you would need that hi a temp for branding (likely 600� to 1000� F). I just thought that the 30-amp terminal might be able to withstand more heat without melting. I will send you the chart