Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Kelton Sharpening System Question

Posts

Kelton Sharpening System Question

#1

Kelton Sharpening System Question

Vicmarc.fan

>The Kelton system comes with two arms and two posts that mount in the arms. The posts are round stock and are clamped down to hold the multi-grind jig or the other one can be used to capture the handle of a tool. The one that holds the jig can be clamped down anywhere on its length and I wonder why. If it is not put back at the same heigth each time you can't repeat a grind. On the Wolverine this part is welded together and I wonder if there is any advantage to having it movable?

Re: Kelton Sharpening System Question

#2

Re: Kelton Sharpening System Question

William Duffield, on the Cohansey

>I've seen turners who do demonstrations turn the rod and cutting edge around and sink them deep into in the handle for protection and compactness when traveling. Seems like that might be an advantage. Also, it allows you to have one handle and multiple tools, again for compactness, expense, and decreased weight when traveling. If you do your regrinding at home, you could build a jig for setting the length, and leave it next to your grinder. Once you have done this, then you never have problems with the settings changing as you grind the cutting edge shorter.

Re: Kelton Sharpening System Question

#3

Re: Kelton Sharpening System Question

Jerry Hall

>I have the Kelton system and have settled on 4" from the center of the wheel to the bottom of the pocket per this sketch:

http://www.aroundthewoods.com/imgssharp/sharpsketch.jpg

I agree you need to have a repeatable height. It turns out that when the pocket is bottomed on my slideout bar I have my desired height. You could make a wooden washer to set to the repeatable height you need. The advantage of the Kelton system would be to be able to adjust the height relative to the centerline of the wheel as you wish. The sketch comes from Darell Feltmate's site:

http://www.aroundthewoods.com/sharp.shtml

I use a variation of his homemade jigs instead of the Kelton fingernail jig because I had already made them, and because the tightening ball on the top of the Kelton fingernail grind jig hit my grinder preventing a full swing to an "Irish" type grind. Since then I believe they have made the ball smaller.

As the previous poster mentioned, I have made a "story board" marking the location of the curve of the wheel relative to the pocket for a particular grind. This gives repeatability even when the dia of the wheel shrinks, as it inevitably will! One end rests on the inner side of the shaft of the grinder and the other rests in the pocket. This is fast and produces very repeatable grinds with one or two sweeps across the wheel.

Hope this helps.

Re: Kelton Sharpening System Question

#4

Re: Kelton Sharpening System Question

Vicmarc.fan

>Thank you very much. I see now what it is for. I will have to check and see if that odd thing I have to hold a gouge for a Ellsworth grind will work here.

Ron