Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Poor man's/woman's texturing tool

Posts

Poor man's/woman's texturing tool

#1

Poor man's/woman's texturing tool

Ken Grunke from SW WI

>There was mention in a thread here a few days ago about using a machinist's knurling wheel for texturing. I had on hand a pair of knurl wheels I purchased years ago, intending to use them for their original purpose--that is, making a knurled pattern on metal handles and knobs. They sat in a drawer unused, until I decided to try them on wood.

I mounted one of the wheels on a piece of 1/2" square keystock, drilled and tapped for a 1/4" axle bolt as shown here:


img

Re: Poor man's/woman's texturing tool

#2

The tool in action

Ken Grunke from SW WI

>The wheel, 3/4" in diameter, hangs below the end of the square steel shaft made from keystock. It cuts at the top edge, just like the real spiraling/texturing tools made by Sorby and Serious. So I set the toolrest just above center, so the top edge of the knurling wheel is at center when the tool is angled down a little.

My wheel has diagonal teeth, you can get them with straight teeth also. They come in different pitch sizes, I think mine is the finest available. Not what I'd call very good for wood, I'll be ordering coarser pitch wheels soon. They're available from any machinist supply house, such as Enco, mscdirect, McMaster-Carr, and Wholesale Tool for under $10 (sold in pairs).

I plan on replacing the square handle with a round shaft, with bracket, like the Sorby and Serious so I can vary the cutting angle.


img

Re: Poor man's/woman's texturing tool

#3

Results: Box Elder hollow form, spiraled lip

Ken Grunke from SW WI

>And here's the results of my first real attempt at using my poor person's texturing tool: A Box Elder hollow form, just a little one--2" diameter, and 2 1/2" high, with a 3/4" opening:


img

Re: Poor man's/woman's texturing tool

#4

Box Elder hollow form, rim detail

Ken Grunke from SW WI

>A closer look at the spiraling--again, the opening is only 3/4" in size:


img

Re: Poor man's/woman's texturing tool

#5

Re: Box Elder hollow form, rim detail

john lucas

>Ken Good job. I have used my small knurling tool but used it in the normal mode with 2 wheels. It produces a very subtle cross hatch pattern. I like the way yours looks.

Re: Poor man's/woman's texturing tool

#6

Re: Box Elder hollow form, rim detail

Ken Grunke from SW WI

>Thanks, John. This rig actually cuts the spirals, as long as there's a sharp edge between the top face of the wheel and the teeth. Start by rubbing the teeth just as you'd rub the bevel on a gouge, then lower that top edge into the wood after the wheel starts spinning.

Re: Poor man's/woman's texturing tool

#7

JL

Re: Nice, subtle pattern to that.

JL

>It adds a subtle detail without overpowering the piece. Pretty!