Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

a first chuck for a Mini lathe

Posts

a first chuck for a Mini lathe

#1

a first chuck for a Mini lathe

arw01

>As a lathe beginner, looking to buy a chuck in the next few weeks. PSI has several for about 1/2 to 1/3 of the "big boys".

Am I doing well to pick up one of these for the next few years, or is the extra $100 a necessity to be happy long term?

Some bowls in the future, mostly be boxes and tops for quite a while.

Alan

Re: a first chuck for a Mini lathe

#2

JL

Re: a first chuck for a Mini lathe

JL

>My preferences would be for a Oneway Talon Chuck. The Penn State Barracuda2 is probably the comparable one to this. I have a Oneway, I haven't tried a Barracuda2. The Oneway is a known quality (and has a good resale value and plenty of adapters).

Re: a first chuck for a Mini lathe

#3

Re: a first chuck for a Mini lathe

Walt Drummond

>I agree with JL. Spend the extra now, and get a 'good' chuck that you will be happy with now and in the future on any new (bigger) lathe that you upgrade to.

The Oneway is my choice. I had one on my midi Delta and now use it on the big Jet. Worked great on the small one and the same on the big.

If you buy a 'cheap' one now, you'll have to lay out the money for a good one later, and the cheap one will lie in disuse. (along with the money you spent on it) Might as well get the 'good' now.

Re: a first chuck for a Mini lathe

#4

Re: a first chuck for a Mini lathe

Mike M

>Look at the Nova G3 its new about 130.00.