Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Tool Rest Base?

Posts

Tool Rest Base?

#1

Tool Rest Base?

Robert W. Henderson

>I'm using an old craftsman lathe. The tailstock and tool rest base both are held on by a bolt and nut. I can live with using a wrench to move the tailstock, but I'd like a cam lock for the tool rest base. The lathe has a 1-3/4" gap between the ways and the center is 4-1/2" above the ways. Does anybody know of something that would work?

Re: Tool Rest Base?

#2

Leo Van Der Loo

Re: Tool Rest Base? *LINK*

Leo Van Der Loo

>Hi Bob

Lee Valley sells a banjo for the old delta/rockwell, and could fit yours, give them a call they are always very helpful and knowledgeable, also Oneway sells banjo's for non Oneway lathes and many use their banjo's on other lathes.

here's two links.

http://www.leevalley.com/wood/page.aspx?c=2&p=30289&cat=1,330,49238&ap=1

Have fun and take care

Leo Van Der Loo


http://www.oneway.on.ca/lathes/non-oneway.htm