Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Woodburner question.

Posts

Woodburner question.

#1

Woodburner question.

Jeremy in LA

>Happy Laotian New Year!! I was given the Colwood Super Pro II woodburning setup as a gift, and then bought a Razertip brand fishcale pen at the Wood Show, only to find out that both the pen AND my cables have female RCA-type connectors. Anyone know a quick fix? I went looking for RCA cables to bridge the gap (the have male ends), but the only ones I can find have a single cable per connector, not dual cables like what comes out of the Colwood. I can wire something up, but would rather not order in the components, etc. if there's another answer. Thanks in advance. - Jeremy

Re: Woodburner question.

#2

Dennis in Southern Oregon

Re: Woodburner question.

Dennis in Southern Oregon

>Jeremy, I just solved the same problem. I heard on this forum that Radio Shack sells an RCA-type connector that is male on each end but could not find one at my local store. Instead, I bought a couple of male jacks and wired them back to back with a 4-inch piece of two-wire lamp cord. This involves a bit of simple soldering though. Good luck. Dennis

Re: Woodburner question.

#3

Re: Woodburner question.

AndiWolfe

>Woodcarvers supply sells the Burnmaster units. These come with an adapter cable that can handle all pen styles. They sell the adapter separately, also.

Re: Woodburner question.

#4

Re: Woodburner question.

john lucas

>Jeremy I just bought a male to male gold plated RCA adaptor at Radio shack. I was actually going for a male to male cable but like you I couldn't find one. I'll go to my local electronic store to get that. I just bought the Razor tip pin to use with my Optima woodburner.