Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Faceplate System

Posts

Faceplate System

#1

Faceplate System

John Leonard

>Craft Supplies catalog has a faceplate system (page 43 On my catalog)that consists of a hub threaded for the spindle and an interchangable faceplate that threads on the end of the hub. Has anyone had experience with this system and if so did you like it?

Thanks in advance,

John Leonard

Re: Faceplate System

#2

Re: Faceplate System

RussFairfield

>That would be the Read faceplate. I used several of them for several years on a 12" lathe, but the wood got larger, the lathes are bigger, and they were replaced by chucks. There was a time when I used a faceplate a lot. I rarely use one of them anymore.

The only problem that they had was only 3 or 4 screw holes and they were small. I drilled more and larger holes so I could use 6 or 8 of the #10 sheetmetal screws and they worked fine for bowls and things up to 10-12" diameter.

Re: Faceplate System

#3

Richard Allen

Re: Faceplate System

Richard Allen

>I have used this system for a lot of things on several different lathes. I will often use one of these faceplates on waste wood. In fact I have 4 of them in use right now. It may be a few weeks before I get around to using the waste wood. But because these face plates are so thin I can stack them for latter use. I also leave a coule of jigs on these face plates. The jigs work on all my lathes as I have hubs for each of my lathes.

Highland Hardware also sells these faceplates.

Re: Faceplate System

#4

Re: Faceplate System

Mark Kauder, Phenix City, AL

>My experience is the same as Russ and Richard. I liked the fact that I could have a 1"x8tpi and a 1.25"x8tpi hubs, and cross use the faceplates.

Mark

Re: Faceplate System

#5

Re: Faceplate System

Stuart Johnson

>Do the hubs fit up tight on the spindle? I have some 1-1/4 x 8 nuts with washers welded on that require a washer to fit snug on my Nova 3K.

Re: Faceplate System

#6

Re: Faceplate System

Mark Kauder, Phenix City, AL

>For my Jet Mini, and my Vega they do.

Mark

Re: Faceplate System

#7

Re: Faceplate System

Bill Crommett

>John: I think the Read face plates are great. I have them mouted on my home brew vacuum chucks, on my doghnut chucks, and on my homebrew giant jaws as well as on a number of jamb chucks that are used so often. The only problem that I have had was one of them had too much wobble and it was cheerfully replaced by Craft Supplies. I also have two adaptors -- one for my General and one for my Shopsmith. I also drilled extra holes for larger screws in some of them.

Bill

Re: Faceplate System

#8

Re: Faceplate System *LINK*

Phil Joines Krum, Tx

>Grizzly sells a 4" faceplate for 1x8 spindles for $7.


Grizzly faceplates

Re: Faceplate System

#9

Re: Faceplate System

Vicmarc.fan

>If you have a chuck with dovetail jaws the faceplate rings on page 37 work for me. I have them on several home made chucks. They also come in handy if you want to remount your work on another lathe.

Ron