Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Now you've gone and done it PM3520

Posts

Now you've gone and done it PM3520

#1

Now you've gone and done it PM3520

Bob Fawcett

>I pulled the trigger and ordered a PM3520 today. It should be here next week.

I need to wire the shop for the 220v feed to the lathe. Can anyone tell me the circuit size requirement? I can't find anything in the manual or on PMs web site. It has the 2HP motor and inverter drive. I am guessing it needs a 30 Amp circuit, but can't confirm it. 10/2 with a ground or 10/3 with ground?

Did you wire yours with a plug, or a local disconnect?

Re: Now you've gone and done it PM3520

#2

Re: Shouldn't need 30A. circuit.

Al Crandall (NE of Indy)

>My 3 hp PM4224 is running just fine on a 20A. circuit with 12ga. wire. I added a cast aluminum handy box with a 20A two pole switch in the cord going from the wall twist lock plug to the lathe's power connection. I was getting some sparking from the prongs of the plug when I plugged it in. Now I know that there is absolutely no load on the cord before I plug or unplug the twistlock. I ran 12-3 rubber cord (two hots and ground)from the twistlock. The cheapest rubber cord at the home centers is sold in the form of extension cords. Check out the prices, and then cut off the molded ends.

Re: Now you've gone and done it PM3520

#3

Re: Now you've gone and done it PM3520

Jerry Whitaker

>I used #12 wire from a 20amp circuit breaker to the wall plug about 20 feet away, put n a 220 plug on the end of the wire connected to the motor. A 30 amp breaker is too big.

Re: Now you've gone and done it PM3520

#4

You can easily figure it out...

Peter Teubel

>1hp equals 746 watts. Watts=Voltage X Amps. 2hp = 1492 watts. 1492 divided by 220v equals about 6.78 amps. Triple that (starting current for induction motors) and you get about 20 amps. That's what you need. Although starting current for variable speed lathes (IMO) is kinda a moot point since we rarely start a lathe at full power.

Re: Now you've gone and done it PM3520

#5

Re: Now you've gone and done it PM3520

Rick Davenport

>Congrats on the new purchase.

You're going to love that big hunk o'iron.

Don't forget to take your wife out to dinner this weekend.

And flowers are in order.

And do the honey-do list.

And wash her car.

And....

you better get started soon, so you'll have time to turn on your new lathe!!

Rick

Re: Now you've gone and done it PM3520

#6

Re: Now you've gone and done it PM3520

Bob Fawcett

>Thanks to everyone who responded, and thanks to the list in general. There is no better resource on the web.

I have wired the shop with a subpanel (the contracto left the temp power pole at the house and I took that for the shop). I wired a 40 amp circuit to the shop with 8/3. From this I take a 20amp 220 to the lathe and I have 2 110 20 amp circuits left. The power pole box conveniently had these already wired to separate outlets with GFCI.

Osolnik said my lathe will be here Monday.

Work will be lucky to get any work out of me on Monday.

Thanks again.