Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

dry osage

Posts

dry osage

#1

dry osage

Tom Sontag - St. Louis

>I am pathetically unskilled at this turning thing but have managed a few spindle projects. I turned a 6+" diameter wheel out of osage that I now want to hollow out some from one face.

(I have a wheel, drilled an axle hole, rechucked on the axle hole and re-turned the outside the make sure the axle hole was centered. Now I want to be able to put a shaft collar on the axle flush with the outside of the wheel; I need to remove some osage near the center hole).

My problem is that the wood has dried and my 1/2" bowl gouge just bounces off the face of the wheel. Is this something I could do if more skilled or am I screwed? I tried an undersized hole saw just to start the counter sink and it bounces off the marble, I mean osage. Any ideas on how I can remove this wood?

I am using something much like the factory grind on my HSS Hamlet. I am coming at the wood just below center and attempting the ride the bevel into a cut.

Re: dry osage

#2

Re: dry osage

john lucas

>Tom A parting tool should do the job. I don't have any trouble with Osage at all. It's hard but cuts fine with a good sharp tool.

Re: dry osage

#3

It's as hard as Woodpecker's Lips

Barry Irby

>But I agree with John, Good sharp tools and it will cut and you can polish it within an inch of its life. I have a hollow form I turned and hollowed through a knot hole. My son gave up on it and let it sit for years and then I finished it. About like turning marble.

Re: dry osage

#4

Re: dry osage

Mike Schwing from Md.

>Tom, I'm not laughing at you, but at the subject line, for I knew what the question/issue was going to be.

Dry osage is like turning marble, as was previously said. Wet, its really nice. Dry - throw it in the fireplace. Unless it is the only piece of wood you have to work with, its not worth the effort, IMO.

Re: dry osage

#5

Re: dry osage

Bill Hale

>Tom

Osage is tough but like any hardwood you must have very sharp tools. Sharpen often and light cuts. I do not know what you have for a lathe but I also think that it does require a little more power. I don't think I would like to make anything other than pens or bottle stopers on a lathe with only 1/2 hp. For bowles etc. a min of 1 1/2 hp or more would be best.

You will enjoy the results of your effort so hang in there and be patient.

Good turning and be safe

Bill in Casa Grande, AZ.

Re: dry osage

#6

It's my favorite for tool handles and mallets.

Phil Joines Krum, Tx

>