Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Bowl Gouge Question

Posts

Bowl Gouge Question

#1

Bowl Gouge Question

Gary R

>Hello all

I am going to purchase a few tools, and had a bowl gouge question. I am turning smaller items on a jet mini. What are the general guidelines for using a 3/8" versus a 1/2" bowl gouge? I would like to get (or grind) to a swept back profile. The 1/2" will give more support, but how small a turning is practical?

I want to give a try on some bowls in the 4" to 8" range, as well as some small vessels.

Recommendations and experiences welcome.

Re: Bowl Gouge Question

#2

for a mini....

TDaniel

>I would go with the 3/8" English measurement (which might be 1/2" if made in the US or Canada) and make certain that you get a deep, "U" shaped flute

Re: Bowl Gouge Question

#3

Re: for a mini....

Rick Allen

>Hi Gary

Unless you prefer the "V" shaped flute, as many woodturners do. Then by all means get the gouge with a "V" shaped flute.

I prefer the 1/2" (English measure) bowl gouge. For smaller work I will grind the heel of the bevel off. This tends to provide similar access and maneuverability in a stiffer gouge.

As you can see, different woodtuners work differently for the same effect. There are some woodturners who prefer the use of scrapers. The end product (4" to 8" bowl) will rarely leave any sign of how the bowl was created.

Good Luck

Re: Bowl Gouge Question

#4

Re: Bowl Gouge Question

Wally Dickerman in Arizona

>When I'm teaching classes to beginners, the question always comes up on what tools to buy. I let them try both a 1/2-inch and a 3/8-inch gouge. (English measure). They nearly always prefer the feel of the 1/2-inch. I do too. I like a combo of a 1/2-inch along with a 1/4-inch for detail work.

Wally

Re: Bowl Gouge Question

#5

JL

Re: As Wally says - get two..

JL

>but they're not cheap. I have two roughing gouges (large and medium) and two spindle gouges (medium and small). What's wrong with a large and a small bowl gouge (or a large and a medium)?

Re: Bowl Gouge Question

#6

Re: Bowl Gouge Question

Gary R

>I had a chance to handle (not turn) a 1/2" and 3/8" bowl gouge. I would agree, I liked the 1/2" feel better. Would I be well outfitted if I purchased the following:

-- 1/2" (English) swept back bowl gouge (Small bowls and vessel work)

-- 1/4" spindle gouge (Fine work - I also turn miniatures)

-- 3/8" spindle gouge (Spindle work, finials etc.)

I have numerous tools for my minis, along with good parting and skew chissels.

Again - suggestions welcome.

Re: Bowl Gouge Question

#7

Re: Bowl Gouge Question

Wally Dickerman in Arizona

>Sounds like a good list. I suggest that you add a heavy duty side ground, round nosed tool. 1-1/2 x 3/8. A wonderful tool for the inside bottom of bowls, especially deep ones.

Wally

Re: Bowl Gouge Question

#8

Re: Bowl Gouge Question

Bob Fawcett

>I bought a Sorby set that had a 3/8" bowl gouge, 1/4" spindle gouge, 3/4" roughing gouge, 1/8" parting tool, 1/2" round nose scraper, 3/4" oval skew. I found it on sale at Woodcraft for $149.