Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Drilling Hollowforms

Posts

Drilling Hollowforms

#1

Drilling Hollowforms

Kieran

>What type of drill bits do most of you use to drill deeper hollowforms? My Forstner bits are not very long and I am having problems finding an extension for them. Do spade bits work as well and if so, do you file the center tang shorter? Thanks in advance for any help/suggestions. Kieran

Re: Drilling Hollowforms

#2

Re: Drilling Hollowforms

Kevin Gerstenecker

>I use Forstner Bits, with an extension. I purchased the extension thru Craft Supplies. It works good if you take your time and watch your feed rate and lathe speed. A spade bit would probably be better for clearing the chips as you drill, but I use a good Forstner Bit. I back it out frequently and vacuum the chips out as the depth increases. Works ok for me.

Re: Drilling Hollowforms

#3

Woodcraft

Pete Kekel - Kentucky

>Woodcraft also carries the extensions. They have several different lengths. I think they're imported from Germany and a little pricey, but well made.

Re: Drilling Hollowforms

#4

Thanks

Kieran

>

Re: Drilling Hollowforms

#5

Re: Drilling Hollowforms

John Lucas

>Highland Hardware in Atlanta and Eagle America both have extensions. Ijust use my bowl gouge and push it in the the middle. It drill nicely. I drill a few inches and then hollow and then drill some more. I used to use a 3/8" drill bit that was 24" long. I still use that one on occasion.

Re: Drilling Hollowforms

#6

Re: Drilling Hollowforms

robo hippy

>A friend loaned me his large McNaughton hollowing tools. I was looking for my forstner bit set up and couldn't find it, so I just used the hollowing tools from the start. They worked just fine, and didn't seem to take any longer. Another plus was that I got to work on the fine art of removing that nipple that is always in the center.

When I did use the forstner bit, I would use a bit that was a bit larger that the chuck. With 6 inches of travel on the tailstock, the chuck, and the bit, that got me in 10 inches deep.

robo hippy

Re: Drilling Hollowforms

#7

Home Depot has them too.

Gary in Zirconia, NC

>

Re: Drilling Hollowforms

#8

Re: Drilling Hollowforms

Bill Hale

>Unless they have changed the extensions at Home Depot & Lowes are for the spade bits and the hole is to small for a forstner.

I guess you could drill it out if the od is large enough.

Bill in Casa Grande, AZ.

Re: Drilling Hollowforms

#9

Re: Drilling Hollowforms

bob davis

>MCLS catalog ,www.mclswoodworking.com has 5" long item#9270,two for 6.95 ea. free shipping. two will actually extend your bit 6"

Re: Drilling Hollowforms

#10

Thanks Again

kkamm

>

Re: Drilling Hollowforms

#11

Re: More on Woodcraft

Al Crandall (NE of Indy)

>Indy Woodcraft carries two brands of extensions. One of them is a lot more reasonable in price. I have their 3/8" and 1/2" extensions for my Forstner bits and for the Silver and Demming drills. I have even ganged two extensions together to get into a really deep turning. IMSM, I believe the price was in the $8 range.

Re: Drilling Hollowforms

#12

Re: Drilling Hollowforms

Vicmarc.fan

>I picked one up at Lowes about a year ago and it works fine with the bits I have.