Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

Chatter tool work ......

Posts

Chatter tool work ......

#1

Chatter tool work ......

GordonP in Sumner, WA

>I don't do much turning, but wondered if you can use a chatter tool on small spindles and pens??

found a great site yesterday - it was on the standard messageboard and they stream videos 24/7 of many wwking shows. I watched one on chatter tool work, which was very interesting - thus my question??

reply via email would be best, but I will check back tomorrow or later today if I get the oppty

Re: Chatter tool work ......

#2

endgrain....

tdaniel

>chatter work is normally done on end grain only of very dense woods. I do not think you could get it to work all the way around on side grain but you might get it to work in spots on some dense wood. It is worth a try just to see what happens.

TD

Re: Chatter tool work ......

#3

Re: Chatter tool work ......

Ken Grunke from SW WI

>It's easy to get chatterwork on spindles with a gouge, if the piece is held in a chuck but unsupported at the tailstock end. It has to be thin enough and/or stick out far enough from the chuck to be a bit flexible.

It helps if the gouge is a bit on the dull side.

Sometimes it even looks like fluted carving, very cool.

I may be stating the obvious, because we all do this unintentionally, don't we? ;)

Re: Chatter tool work ......

#4

Re: Chatter tool work ......

Ed Karch

>Here is a small bowl chattered fore aft and side with chatter tool.


img