Silent Compressor Fix-LONG Reply!
Larry Mart
>I also made a few inquires to turners that use the Powercrafter tool and asked what they use for an air source. John Lucas mentioned Binh Pho who is probably the most well know user and he just replied to my email. I'll quote his answer:
Hi Larry,
Quiet compressor is very expensive that is why you don't see many people use
them except the dentist or Lab work.
The Powercrafter requires 3CFM to run at the recommended speed. The one I
use at the demo only produce around 1.8 CFM, but I was able to use it for
demo because I didn't have to pierce continuously, while I was talking, I
allow the compress air building up in the tank. I don't use my quiet
compressor at home, it intended for demo only because it's not enough power
to run continuously. At home I use the noisy one just like every one else,
but I have 80 gallon tank so it only comes on once in a while, I also put it
in the different room to reduce the noise.
However if money is no object to you, here is where you can get the quiet
compressor. The one I have, it around $1,000, but if you want to get the
proper one for the continuous use, it will cost you around 2,000 -3,000.
Go to this website and check it out: www.silenaire.com
Good luck
Binh
I also called the manufacturer, Silentaire, and they told me I'd probably burn up the $800 compressor using it that much.
Another friend checked with an aircraft acoustical engineer at his work and he sent me this:
"He can use simple plywood for the enclosure box - 3/4" thick gives 24 to
35 dB transmission loss across all frequencies which is equivalent to
dropping the noise level to less than 1/4 of what it is unmuffled.
He'll want to seal around all the seams in the box with a common sealant
like silicon since small leaks can really degrade the acoustic
performance.
More challenging is the air intake. He'll need to make a duct that is
lined with foam and is as long as practical given his work space. He'll
want to make the duct as narrow as possible so that the passage between
the foam walls is thin. I'm guessing that the dominant compressor
frequencies are rather low so he'll want 4-6 inches thick of foam - not
sure what Home Depot has for material but mattress egg-crate foam would
probably work. If this duct could be 5-6 times longer than it is wide
(in the narrow dimension) and if the opening could be pointed away from
the work space that would be best. I'm guessing he could run the air
hose out of the inlet duct to avoid making another opening in the
enclosure. I'm envisioning a tall narrow inlet duct with the sidewalls
covered with foam, the floor is one "wall" and the top of the duct may
be covered with foam too. If this could be 4 inches wide between the
foam (16 inches wide including the foam), and a foot tall, perhaps 2
feet long it should work well. "