Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

large pen mill vs. sander jig? *LINK*

Posts

large pen mill vs. sander jig? *LINK*

#1

large pen mill vs. sander jig? *LINK*

Ken Platt (Granby, CT)

>Folks - In making a larger type pen than I've done before (Berea El Grande) I found that my 1/2" pen mill isn't big enough (the larger tube of this kit is 33/64ths diameter). So I went online to buy a 3/4" trimmer, but while poking around found something called a "universal pen blank trimmer" (link below). I was wondering if anyone had used this, and how well it worked. I can't tell from anything I found how it manages to, as claimed, fit all tube sizes. If that claim is true, it'd save me time over making shims to fit over the shaft of my current barrel trimmer. At about $18, it's comparable in price with the 3/4" barrel trimmer cutter also (those seem to vary from $13 at Packard to $20 at Craft Supplies).

I've looked at plans for shop-made sander jigs, but the ones I found seemed a bit complicated or needed materials I didn't have (an extra pen mandrel, for example). If this jig works, I'd much rather spend the $18 for it and spend my time making pens.

Thanks for all thoughts, experiences, etc, as well as any ideas for any other "quick n dirty" ways to square a large pen tube to the blank.

Ken


http://www.pennstateind.com/store/pksquare.html

Re: large pen mill vs. sander jig? *LINK*

#2

Re: large pen mill vs. sander jig?

Jim Shaver - Oakville, Ontario

>Hi Ken,

I have the Penn State set and almost never use it now. I Use a set I bought from Craft Supply, it's much better in my case, The guides fit really well and the cutter (3/4) is sharp and easy to keep so with a diamond plate...I never had much luck with the Penn State set.

take care,

Jim

Re: large pen mill vs. sander jig? *LINK*

#3

Make your own *Pics*

Ron in Drums PA

>



Re: large pen mill vs. sander jig? *LINK*

#4

Re: Make your own *Pics*

Jim Shaver - Oakville, Ontario

>Hi Ron,

Good example as well, I have done just that too with good results!

Take care,

Jim

Re: large pen mill vs. sander jig? *LINK*

#5

Re: Make your own *Pics*

Terry Quiram, Roanoke Illinois

>I have a home made insert just like the one pictured for the Big Ben pens I have been turning. Mine is an orphan corian blank with the tube glued in that I turned down to fit. It works great.

Terry

Re: large pen mill vs. sander jig? *LINK*

#6

Re: Make your own *Pics*

Bruce Wiseman

>Going back to Ken's original question; I made a jig almost like the Pen State sander. I used a piece of an old 7 mm mandrel for the post. I've used it a few times and then went back to the pen mill. You end up having to make (or buy) sleves for the larger tubes for use with the sander. Otherwise the tube slops around and ends up not being square. All in all the pen mill just seems to work better.