Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Wood for end-grain turnings

Posts

Wood for end-grain turnings

#1

Wood for end-grain turnings

Bill Howatt

>In my never-ending search for something I am good at, I am starting to try some end-grain turnings. I have made a couple of goblets out of dry maple and I've done some christmas ornaments out of dry spruce (old Christmas tree).

I have some maple and other free wood in my storage but it is in various stages of dryness.

Should I wait a long time until they are dry and then turn them?

Can I do the rough turn to 10% of diameter, dry, finish-turn, trick like I do on my bowls?

How dry should they be if I just want to do a one-time finish turn?

Any other advice?

Thanks,

Bill

Re: Wood for end-grain turnings

#2

Re: Wood for end-grain turnings

Wally Dickerman in Arizona

>You can do all of the above. Left alone, they will take a long time to dry, if ever. You can rough turn them, but with end-grain you can turn them to a lot less than 10%. Warping out of round with end-grain, especially if it's semi-dry, will be minimal. Do protect the wood with a sealer. I use a generous coating of Johnson's paste wax. You can also turn them to a finished thickness while they are still wet. Just be sure to have the wall thickness nearly the same throughout to prevent cracking.

Wally

Re: Wood for end-grain turnings

#3

Re: Wood for end-grain turnings

georgetroy

>Wally has the right of it Bill. Wet turning of end grain is fun. It gives you a chance to use some small limbs. I had one of my apple trees split off. I went down yesterday and cut some turning stock. All from 3-4" in diameter. These little guys make great vases and goblets. Go forth it don't wait. I use super glue to reinforce tenions and lacquer inside & out to reduce cracking. Knots are a bonus just keep them super glued. GT

Re: Wood for end-grain turnings

#4

Re: Wood for end-grain turnings

John Lucas

>Bill e-mail me and I will explain how I turn christmas ornaments from green wood.

Re: Wood for end-grain turnings

#5

Vases

Bill Howatt

>George,

If you hold your vase in a chuck, approximately how long can the vase blank be to end-grain turn it without a steady? I'm thinking of a blank around the 3-4" diameter range. My chuck is a Oneway Stronghold.

Thanks,

Bill

Re: Wood for end-grain turnings

#6

Thanks everybody, very helpful!!!

Bill Howatt

>

Re: Wood for end-grain turnings

#7

Brad Vietje

Re: Vases

Brad Vietje

>Bill, I'll jump in here for George, but he may have a different answer...

I'd say it really depends on the jaws you use, how well you prepare the blank between centers for those jaws (getting the size and shape correct), and the character of the wood in question. Some limb wood or small diameter tree trunk sections are very slippery, especially spring-cut wood, and when working near the diameter of the bark/cambium layers, they can tend to be pretty juicy (slippery). Some people actually glue the jaws to the wood with CA (sticks to damp wood), and I'd imagine they scrape this off after heating it -- CA gives up when heated -- but I have not resorted to this.

In my experience, you're better off with a smaller diameter, well-shaped tenon that is well below the bark and/or cambium than going for the maximum size you can chuck.

Safe Spinning,

Brad Vietje

Newbury, VT