Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Domestic, Figured & Live Edge Hardwoods in Stock. Best Prices for Serious Woodworkers.

A Screwy Question *LINK*

Posts

A Screwy Question *LINK*

#1

A Screwy Question *LINK*

Rick Davenport

>I'm in the process of purchasing one of those spiffy eccentric turning attachments that Ken Grunke makes (see link).

He has asked me for the screw size on my Talon and Stronghold chucks.

I assume it's the same for both.

I checked the manual and can't find any mention of the size.

Does anyone out there know?

Thanks,

Rick


Ken's Eccentric Page

Re: A Screwy Question *LINK*

#2

Leo Van Der Loo

Re: A Screwy Question

Leo Van Der Loo

>Hi Rick

My Stronghold and Talon woodworm screws are exactly alike and interchangeable.

Have fun and take care

Leo Van Der Loo

Re: A Screwy Question *LINK*

#3

Re: A Screwy Question

Rick Allen

>I believe the screws which hold the jaws to the chuck are 4mm. The woodworm screw I believe is 3/8".

Re: A Screwy Question *LINK*

#4

Leo Van Der Loo

Re: A Screwy Question, if understood wrong,

Leo Van Der Loo

>The screws that hold on the jaws and rubber bumper buttons are all 6mmx1.0mm.

have fun and take care

Leo Van Der Loo

Re: A Screwy Question *LINK*

#5

Re: A Screwy Question

Rick Davenport

>Yikes!

Sorry for the confusion.

What Ken needs is the size for the screws that hold the jaws to the chuck.

Thanks Rick and Leo for your prompt responses.

So far it's either 4mm or 6mm.

Anybody else want to weigh in?

Rick

"Clueless in Seattle"

Re: A Screwy Question *LINK*

#6

Leo Van Der Loo

They ARE 6mm D, and 1mm thread pitch

Leo Van Der Loo

>

Re: A Screwy Question *LINK*

#7

Re: A Screwy Question

Bill Howatt

>The screw that hold the jaws are 6mm. The 4mm screws that come with the chucks are hex head for inserting/removing the taper-lock adapter which matches the spindle thread.

Bill

Re: A Screwy Question *LINK*

#8

Thank you Leo and Bill and Rick

Rick Davenport

>

Re: A Screwy Question *LINK*

#9

Re: A Screwy Question

Gil Jones

>I do not know the size of your chuck jaw screws, but the measurement Ken needs is the 'diameter' of the screw. My VicMarc chuck uses 5mm screws, which mikes out at .193". If you have an accurate vernier caliper, or a micrometer, just measure how thick the jaw screws are. I have had mine for only a couple weeks, so I am sure that I have much to learn about its use. It sure does allow me to turn some interesting shapes.