Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Horrible Fright lathe

Posts

Horrible Fright lathe

#1

Horrible Fright lathe

Bill Houghton, cold and rainy in Sebastopol, CA

>I think I already know the answer to this...a coworker is selling a Harbor Freight lathe that belonged to her husband - light duty, possibly an integral motor, made in China.

It wouldn't be my permanent lathe, but my current shop is very small, no room for a permanent lathe, and this would be temporary until I could get my old, heavy, Clausing-made Craftsman up and running.

Any experiences with the Harbor Freight lathes?

Re: Horrible Fright lathe

#2

Re: Horrible Fright lathe

john lucas

>Bill I've turned on a lot of lathes both junk and great. They all work and they are all fun. Good lathes are more fun. You can buy a Jet mini lathe right now for just a little over $200 if you search. It is far better than the Harbour Frieght and doesn't take up much space. In fact you can store it on a shelf. It will take a bed extension if you decide you want to turn longer stuff later.

If the HF is really inexpensive I would get it and learn on it. If they want $150 or so I would save my money and get the jet. You won't believe the difference in quality between the two.

Re: Horrible Fright lathe

#3

Thanks *LINK*

Bill Houghton, cold and rainy in Sebastopol, CA

>It's a tough decision. I also own an old Tomlee lathe (see link below) on which I started replacing the bearings a year or so ago to use as the occasional lathe until I have the space for the big iron, but between the job, the house, and caring for my mom, I haven't made much progress on getting that up and running.

$$ are a consideration. My coworker is asking $100 for it, with a 2x6 table...I might as well just go look at it.


Tomlee lathe, kind of a neat tool

Re: Horrible Fright lathe

#4

Re: Thanks

john lucas

>Bill, you have a great toy to restore. My first decent lathe after selling the Delta 46-700 was a J-line that I rebuilt. It wasn't all that different from your lathe. These are good lathes to learn on.

As long as you go into the HF lathe knowing that it will have some irritating problems you will still enjoy making things with it, and will learn more about what to look for in a good lathe.

Re: Horrible Fright lathe

#5

Oh, Man! That Takes Me Back!

Barry Turner

>That photo takes me back a few years. The very first lathe I ever had was an old Tomlee, maybe not this very same model, but close. Like yours, it had angle iron for the bed. It wasn't a very good lathe, as I recall, very prone to vibration. Then I moved up to an old Craftsman with a cast iron bed.....about a 1949 vintage......then to a Jet Mini and now a Stubby 750.