Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

Any experience harvesting Ash?

Posts

Any experience harvesting Ash?

#1

Any experience harvesting Ash?

Dave Belser

>The city recently cut a large Ash tree with 3-4 foot dia trunk. Tomorrow I will be cutting it up for turning. Last summer got to cut up some other large Ash sections that were straight and clear so the decisions were pretty easy. I basically just cut the sections into 4-6" slabs and then cut disks out. I saved some in between parts for spindle work. As I said all nice straight clear stuff.

This new tree is a different story. In addition to the usual dark center of ash there is also a lot of ant stain like I've seen in some maple. There are many crotches and large (8-12") scabs over spots where branches were trimmed. It looks like there my even be a burl.

Is there anything figure or grain specific to Ash that I should look for? I know to some extent it's always a roll of the dice once you start cutting, but any advice or experience would be great.

Thanks,

Dave in NH

Re: Any experience harvesting Ash?

#2

Re: Any experience harvesting Ash?

Tony

>Yeah, that stuff can be very toxic. You'd better wait until I can get there to take it off your hands...err...save you from it.

;)

Just remember the ash is going to start splitting/cracking almost as you cut it, this time of year.

Re: Any experience harvesting Ash?

#3

Leo Van Der Loo

Re: Any experience harvesting Ash? *LINK*

Leo Van Der Loo

>Hi Dave

I've cutup some large ash and small as well, I find ash has figured grain consistently, in crotch an branch trunk junctions. even small branches have figured wood around them.

I've never had a burl with the multi eye or growth ends but had some growover burl i'll call them.

I had a couple of pictures up a little while back, see the link, also have some pictures in my albums of some ash and ash turnings.

Make sure you keep enough wood below the crotch and the branch junction, and seal your wood.

Have fun and take care

Leo Van Der Loo


http://www.woodcentral.com/cgi-bin/turning.pl?frames;read=101870

Re: Any experience harvesting Ash?

#4

Re: Any experience harvesting Ash?

Jeff Rich

>Unfortunately, the emerald ash borer has hit our area so a lot of ash trees are being cut down.I believe this is to protect other species. I wish I could get a hold of some, but they are not letting any of it go.

I have harvested some smaller ash and it was pretty nice to work with, if you get the pith out.