Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

My new Lathe

Posts

My new Lathe

#1

My new Lathe

Wayne Kuhn

>here is my new set-up.

Grizzly G0462. Along with my grinder, buffing set-up and $45 Penn State chuck. The grinder & buffer get moved to my bench 2 steps away wilst I'm turning.

I got the griz in late January and have ben giving it a workout.

Yesterday I Turned a 27lb, 12" rnd x 7" thick hunk of hickory (acording to my neighbor, but I believe it is poplar)on a 3" faceplate fron Don Pencil. This has been my largest piece to date. I was little worried but it did not skip a beat. Yes the lathe is bolted to the floor. I Was working on the inside when I noticed ring/wind shake. oh well, on to the next piece. Just thought I would share my Joy.


img

Re: My new Lathe

#2

Re: My new Lathe

john lucas

>Wayne Thanks for reporting on the Griz lathe. I try to keep up with lathes so I can pass the info on but I did not get many responses from owners of Grizzly lathes so I don't know much about them. Keep us posted on your likes and dislikes. I thought that looked like a decent lathe for the money but you never know until you own one. Glad your having fun with it.

Re: My new Lathe

#3

Re: My new Lathe

Wayne Kuhn

>I have no issues as of yet (knock wood), I do believe 2 hp is very generous for this lathe. If I managed to pull 12 amps, which is what a 15a 120 v breaker should handle with no problem, iwould be gettig 2 hp. However I measured a turning with a parting tool (unscientific) and only measured 5 amps= .8 hp. I have yet to stall the motor or spin the pulleys on the belt.

Other than greasing the reeves drive shaft, a minor modification to the drive cover so I could get it off and a touch of loc-tite on my banjo bolt, no issues. I has done everthing I have asked of it to date. Bolting it to the floor was a major improvement also. I am leary of the tool rest extension. I have not used that to date.

Re: My new Lathe

#4

Re: My new Lathe

Chris K in MD

>COngrats Wayne! cant wait to see what you are turning on your new lathe!