Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Collet Chuck Help Needed!

Posts

Collet Chuck Help Needed!

#1

Collet Chuck Help Needed!

Doc

>I have a collet chuck so tight in a turning blank that I can't get it free from the blank. This is my first time using a collet chuck so I must have made some sort of rookie mistake. I have the bowl turned but the collet chuck won't loosen up.

Any suggestion will be greatly appreciated!

Doc

Re: Collet Chuck Help Needed!

#2

Re: Collet Chuck Help Needed!

kevinT in T Bay

>When that same thing happened to me, (5 billion times) I've taken the thing off the lathe and sprayed some Releasall in the shaft.

Re: Collet Chuck Help Needed!

#3

Re: Is it a collet chuck or scroll chuck?

Al Crandall (NE of Indy)

>Collet chucks generally are designed to grasp diameters smaller than you might use to hold a bowl with. Scroll chucks, on the other hand, will grasp diameters up to around 6 inches. Some scroll chucks are tightened with "tommy bars" and some are key driven. Some key driven chucks tighten the same direction as other chucks do when they are being loosened. A little more information might help us to help you.

A collet chuck will usually have a right hand thread on the collar which closes the collet. Does it have a spanner wrench to apply pressure to the collar? Are you sure you are turning it CCW? If you really need help with a scroll chuck, tell us the brand.

Re: Collet Chuck Help Needed!

#4

Re: Is it a collet chuck or scroll chuck?

Doc

>Al

It's definitely a Collet Chuck.

Re: Collet Chuck Help Needed!

#5

Re: Vibration is a thread's worst enemy.

Al Crandall (NE of Indy)

>That's why fine threads were invented; they resist vibration better than coarse threads. So if you have stuck threads on a lathe appliance, my suggestion is to smack the wrench with something which has a goodly amount of mass. The momentary shock should jar the stuck threads into submission. If there is no spanner wrench to apply to the collet collar, a strap wrench wrapped around the collar and smartly hit should do the trick.

Re: Collet Chuck Help Needed!

#6

Leo Van Der Loo

Re: Collet Chuck Help Needed!

Leo Van Der Loo

>Hi Doc

If I understand it right, you have the collet inside the blank and after loosening you can not get it out, if that is the case, than I suspect that you have sawdust/sanding dust or dirt in the narrow gaps of the collet and the collet can not get smaller and come out.

Tighten it back up and blast out the crap and you should be able to get it out.

Hope this helps

Have fun and take care

Leo Van Der Loo