Re: Go or No Go
Dave Belser in NH
>Rick if this was my turning and I really wanted to finish it here is what I'd do:
- Flatten the top and then use CA glue to attach a piece of 1/2" birch or other strong SOLID plywood. Make sure it's glued well around the rim of the piece
- Turn the plywood so it's about 1/2" larger than the rim of the piece.
- Wrap decent strong tape around the outside
- Hollow out through the ply and finish the inside
- Part off the plywood ring and finish the rim
- Remove the tape and your done.
I've used this technique on a few bowls that were missing large chunks of their sides. One aspect about turning that I really enjoy is pushing the limits -SAFELY- of what I'm capable of doing. Take your time and check the integrity of the piece as you go. Worst that will happen is it might fly apart - but you will be facing the top wearing a face shield, not in the line of fire while you hollow it. Also the tape will help contain it.
Good Luck & Be safe
Dave