WE MOVED...
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

Delta 46-715

Posts

Delta 46-715

#1

Delta 46-715

Jim Rutten

>Hello all,

My lathe, a Delta 46-715, has started to vibrate like crazy (i.e. when I put my extension rod for my beall buffing system on it probably has a variance of 3/8 ths inches on either side). I know there has been much derogatory said about this lathe but I got mine before all that came out. Until this Christmas it has been a good lathe with very little vibration. Anyway, here is my question. It seems to me that Bill Boehm (sp) figured out the problem with these lathes and published a faily in-depth solution, something to do with a pulley problem. I have seached the archives here and at AAW and can't find anything. Does anybody know if this exists? Thanks for your help.

Jim

Re: Delta 46-715

#2

Re: Delta 46-715

Steve in NC

>I had posted a similar question last month. The sudden vibration is likely caused by on of the pulleys come loose and creating sloppy fit on the motor shaft. Mine ended up breaking apart. I had contacted Delta Tech support with little help. Based on suggestions here, I called Cust. Service. They sent a box of parts out at no cost. Here is what I did.

Replace the entire pulley assembly on the motor.

Replace the keyway

replace the spring on the motor shaft

replace all set screws

Cleaned and lubed the guides on the upper pully and motor shaft

Replace the belt

After all this the vibration was better but not gone.

Going a bit further, I adjusted the motor to get good belt alignment at the speed I use most often. Then I added some weight to the stand and tightened all the stand bolts. This helped a bit more.

While I was waitng for the parts, I put a fixed pulley on the motor and used it as a single speed. Sure enough there was no vibration.

It is so disapointing that Delta would continue to sell such a poor product.

If you want to search on a previous thread, the subject line was "Delta Lathe Blues"

Re: Delta 46-715

#3

Re: Delta 46-715

Earl Eyre

>I, too, had this lathe. I, too, had this problem and Steve has covered the problem. It is not just this lathe but any with the Reeves drive. They work great until they get worn. And worn they get. Tear into it and you will decide you either have to replace the whole thing like Steve did and hope it works or it wont. He went to a fixed pulley system. But there is no easy way to then change speeds.

The Reeves drive was the only way to get a variable speed drive but it now is an outdated system. Like Steve, I kept replacing things and never got all the vibration out. But you pretty much have to rebuild the Reeves drive completely.

Sorry for the bad news. I bought mine before I knew the problems. Finally got rid of it rather than continually fighting it.

Earl

Re: Delta 46-715

#4

Re: Delta 46-715

Jim Rutten

>Thanks, Steve and Earl.