Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Bob Davis -jet mini

Posts

Bob Davis -jet mini

#1

Bob Davis -jet mini

john lucas

>Bob I had time to do a little playing tonight. The jet has a 500K pot with 3 wires so I'm not sure what to do about those. I couldn't get a schematic from jet. Apparently the techs don't even have one, they just swap boards when they have problems.

There are 3 adjustment pots inside. Vr1, Vr2 and Vr3. They adjust the speed of the lathe but since I can't find a schematic I don't know what they do. I did find out through playing that VR3 can slow the lathe down a lot. I don't know what it will do the torque because I only have defective motors to play with.

If you mark where this pot is set and then adjust it by turning it gently CW or CCW you can play with it and see if it will do what you want to do. It won't go to zero, if you want that just turn off the lathe. It will slow down to about 60 rpm or so. If it reduces the torque you can alway put it back where it was originally.

I'll try to play with it more later in the week. I have to work the next 2 nights.

Re: Bob Davis -jet mini

#2

Re: Bob Davis -jet mini

JKJ in East TN

>>...I couldn't get a schematic from jet.

Can you create a schematic by tracing the board(s)? We used to do a lot of that to repair and modify circuits. Unless they use custom ASICs or potted components it's usually not too hard.

JKJ

Re: Bob Davis -jet mini

#3

Re: Bob Davis -jet mini

Phil Joines Krum,Tx

>John,

You can send the lathe to me and I'll play with it. :>)

Does anyone know who makes the controller? If it's a version of one commercially available we could probable find the programing information.

Re: Bob Davis -jet mini

#4

Re: Bob Davis -jet mini

john lucas

>John It could be done but it's a pretty complicated circuit. Apparently has ramp up and ramp down times and probably some sort of feedback to control circuit speeds. It's way beyond my limited electronic skills. I learned on tubes.:)

Re: Bob Davis -jet mini

#5

Re: Bob Davis -jet mini

john lucas

>Phil I made a bunch of phone calls to jet and some of the service centers and got nowhere. It's probably some generic board made in Taiwan but I couldn't find anyone who had a schematic. We're in the throw away society now. They just change out the board and don't try to repair them anymore.

Re: Bob Davis -jet mini

#6

Re: Bob Davis -jet mini

bob davis

>thank you for all the effort..maybe this will bring something out of the woodwork!

Re: Bob Davis -jet mini

#7

Re: Bob Davis -jet mini

John Lucas

>Bob I got a couple of ideas sent to me in e-mails so I will try them out later in the week. Sorry it's taking so long but sometimes I just have to put in a lot of overtime. That's the nature of being a photographer.

Re: Bob Davis -jet mini

#8

John check your e-mail when you get a chance.

Eddie Pacheco; San Jose, Ca.

>

Re: Bob Davis -jet mini

#9

Re: Bob Davis -jet mini

bob davis

>thanks again,john