We value your privacy.
We use cookies to enhance your browsing experience, analyse site traffic, and personalise content.
By clicking “Accept all”, you consent to our use of cookies. You can also choose
“Essential only” or learn more.
>I had the pleasure of going over to JKJ's place yesterday morning and spending some time with John and his WoodMizer. I took a truck load of cut up logs over and we turned them into turning blanks.
The WoodMizer made short work of cutting the blanks. It made it a lot easier then using a chainsaw.
>Thanks for showing Dick. That wood Mizer and 2 trucks cost a lot more than all 6 of my lathes. Good turning. You posted some of your finished product from this load. GT
>You'll have enough wood to turn all week now! I want to see some turnings from those spalted pieces. Too bad we ran out of time before getting to some of that walnut on the flatbed in the background.
We learned a lot about cutting small chunks.
The fixture to hold the sections was simply a couple of 8/4 boards fastened into a strong L shape. I cut the fence into a high section and a low section. We clamped a chunk against the high fence with the log clamps, skimmed the top surface flat, and cut out blanks and pith until we hit the fence. Then slid the fixture to the low part of the fence, flipped the remainders, then skimmed the other side and finsished up. When I get time, I want to try making a heavy "workbench top" to set on the bed with holes bored for dogs and clamps. I think this will let me hold a wider variety of shapes securely. You do NOT want to cut into something that is not securely clamped and might move or roll even a little bit - that would be like cutting into an unsupported round or block on a vertical bandsaw. Could get exciting with 15 hp pulling the blade.