Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Polyester Resin and DC

Posts

Polyester Resin and DC

#1

Polyester Resin and DC

R Peterson

>Hey guys and gals,

Just got some polyester resin and dyes to start making our own PR pens and was curious if there were concerns about PR dust and fumes going up my DC. I am imagining the chemical reaction (heat) to be done, but a little leary on mixing this in with the sawdust. Also, are the fumes a concern being in the ducting?

This is at a high school, so safety is of utmost concern. Biggest threat seems to be during cutting castings into blanks on bandsaw, which sucks up the dust and fumes. Otherwise, debris created while cutting on lathe (with appropriate mask) is not near DC so we just sweep up and dump in garbage.

By the way, the kids are becoming as addicted as I with our Midi and turning pens, candlesticks, etc. I can't imagine how we used to manage without this toy in the shop.

Thanks,

R. Peterson

Re: Polyester Resin and DC

#2

Re: Polyester Resin and DC

John Lucas

>I've drilled and cut and turned a lot of plastic and resin and don't think there it a problem. I use my dustcollector whenever I do this and so far nothing has happened. I know you won't get enough heat to cause a problem and the fumes are much less hazardous than CA glue.

Re: Polyester Resin and DC

#3

Re: Polyester Resin and DC

Fog Tanner

>There is more danger from the mixing than the PR dust in your collector. I wear glasses, but always use goggles when mixing PR, the catalyst can cause eye damage. The dust from cutting/sanding is no more of a problem than with wood. I have used PR, with an addative to make it cure quicker, over wood as a sealant and never had an issue with the heat. The same would be true if you were using epoxy, my preference over PR for a number of reasons. I do turn and sand epoxy on my lathe with my dust collector running with no problems. And the dangers of breathing wood, PR, or epoxy dust are all the same. That wood dust in your lungs isn't going to "biodegrade" until the rest of your body does - which is normally after you no longer have any use for it. So, just exercise caution when sanding on the lathe, regardless of the material. That and the eyes are your biggest concern..

Re: Polyester Resin and DC

#4

Thanks for the help

R Peterson

>Thanks guys,

I feel better knowing there isn't much risk of an explosion happening with kids around.

R Peterson