Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

Jet Lathe Question

Posts

Jet Lathe Question

#1

Jet Lathe Question

Ben Borowsky

>My Jet mini-lathe's live center has started to make grinding noises and heating up. Is this repairable, or is it junk? Thanks in advance,

B2

(Boy, have I been away for awhile. Looking at some of the things that people are posting has changed from a humbling experience to a positively awe-inspiring one...)

Re: Jet Lathe Question

#2

JL

Re: Jet Lathe Question

JL

>It's probably toast. You may consider investing in a new one. Fortunately there are many out there. I am personally lusting after one of the Sorby Steb live centres.

Re: Jet Lathe Question

#3

Re: Jet Lathe Question

TheHeretic

>I went through two before I finally found one that is excellent. There are some things that you just need to get better quality items to run with.

Dean

Columbus OH

Re: Jet Lathe Question

#4

Re: Jet Lathe Question

Ben Borowsky

>Thanks, guys. Do you have a brand recommendation for a quality one?

Re: Jet Lathe Question

#5

Re: Jet Lathe Question

John Lucas

>Ben I have had a Nova live center for years. I love it. It has lots of different tips and since the tips fit in a short #2 morse taper you can easily make wooden adaptors to make this center very versatile. You can even use the tips in the headstock if necessary. I'll bet I've used this thing for 12 years or so and still haven't worn out the bearings.

Re: Jet Lathe Question

#6

Re: Jet Lathe Question

Ben Borowsky

>Thanks, John

Re: Jet Lathe Question

#7

Re: Jet Lathe Question

Ken Grunke from SW WI

>Ben, it may be possible to replace the bearing(s) but I don't know how one would remove the old ones. If you were gonna toss the old one or just have it sitting around in the way, I'd be interested in it for the cost of shipping. Email me, removing the "ma" at the end of my address.

Re: Jet Lathe Question

#8

Re: Jet Lathe Question

William Duffield, on the Cohansey

>It's not toast. The JET live centers do not have sealed bearings, and dust and shavings can get into the bearings from either end. You can disassemble them, clean the bearings (naphtha or acetone work), relubricate (20 weight non-detergent motor oil works) and reassemble. That will probably get it up and running again. Then, you will probably want to develop a strategy to keep dust out in the future. Rule number one is, whenever possible, to operate it and store it with the removable center tip in place. Rule number two is to oil a small piece of paper towel and insert it in the hole in the morse taper to keep dust from getting in that end. If, when you disassemble the bearings, you find that they are worn out, they can be inexensively replaced. Sealed bearings are more expensive than the originals, but might be worth the extra cost to you, depending on how far away your nearest bearing dealer is. If you don't feel up to doing the repairs yourself, you can take it to any JET service center or to any machine shop that sells bearings. Even if you get another live center, you should fix and keep the original JET as a backup.