Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Turntek Hollowing Tool

Posts

Turntek Hollowing Tool

#1

Turntek Hollowing Tool

Bill Hale

>I purchased the new Turntek hollowing tool at the Desert woodturners symposium and had two of them break at the weld. Below is an E-Mail I sent to the company. I will keep all advised as to what they have to say.

I purchased at the desert turners Symp.

Purchased on Sat. took home and mounted on the lathe and the weld broke as I mounted. No use.

Exchanged it on Sunday.

Mon. mounted the new one on the lathe and the weld broke. No use.

I believe the tig weld is bad with low penitration and possibly should have been a mild steel weld for better copatibility of materials.

I will be taking this one to a local welder for repair.

Will you pay for the repair ?

Bill Hale

Good turning and be safe

Bill in Casa Grande, AZ.

Re: Turntek Hollowing Tool

#2

Re: Turntek Hollowing Tool

Stan Townsend

>I am still in Phoenix and will return to Tulsa by Friday. I got a tip about the weld failure the second time and examined the first bracket you returned. I discovered that the welder had used silicon bronze instead of mild steel. This was only on some of the brackets. I will replace any of the brackets with the bad weld. Send me an E-mail at my site Staninvent@cox.net I will send you a new bracket with a postpaid return label so you can return the bad bracket at no cost to you. This was a sub out job on the welding and I believe the welder just got a bronze welding rod mixed in with the steel ones. I am sorry for the mix up. Pass the word. Stan