Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Sharpen your tools

Posts

Sharpen your tools

#1

Sharpen your tools

Wayne Kuhn

>Any beginners out there like me and having trouble getting the ribbons to fly?

My problem was dull tools. I was scared to take my new Ellsworth gouge to the grinder thinking it would no longer be an Ellsworth gouge when I was done. Boy was I wrong.

I sat down, got info off the web, printed it, took it into my shop and became one with my wolverine jig, grinder (slow speed)and my Ellsworth gouge. After about a half hour or so of fiddling with the varigrind attachment I told myself nothing ventured nothing gained. I turned on the grinder. In less than a minute sparks were dancing over the edge. I took the gouge to my bowl blank and was absolutley amazed, the ribbons were flying. I became giddy and turned that blank into a pile of ribbons.

Frequent sharpening is the key. If your workpiece is becoming difficult, catches,tearout,no ribbons. Go to the grinder 20 seconds and your back to lathe.

No wonder I'm hooked. As a beginner, everyday I turn something new is discovered. Hope this helps someone.

Re: Sharpen your tools

#2

Re: Sharpen your tools

john lucas

>Wayne Glad you've jointed the sharpening brigade. In an earlier post I mentioned how the best thing that happened to me was to assume that my tools were consumeables and would get used up by sharpening. What happened may have actually saved my tools. By sharpening more often I not only remove less metal because it isn't as dull, but also remove less metal because my skills at the grinder have improved.

Any time it feels like your having to work at turning, stop and sharpen. It should cut like butter and take very little pressure from your hands unless you are taking big cuts. Any time it doesn't feel like this it's dull.

Re: Sharpen your tools

#3

Good advice *LINK*

Bob Fawcett

>I am a beginner too. I bit the bullet and sharpened my gouges with a fingernail profile from a jig I made. Here is a link to make your own.


Grinding jig