Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Bias turned

Posts

Bias turned

#1

Bias turned

RevDoug

>I was asking about instruction on turning on the bias a while back. Here's the first of the experiments. The wood is some live oak that I brought back from Katrina land. The finish is Danish Oil. A couple of coats of paste wax will go on in a couple of days. Comments and critiques are welcome. You can only help make me a better turner.

Turn 'em round,


img

Re: Bias turned

#2

Re: Bias turned

Dave Belser in NH

>Nice job Doug!

I'm a little new to turning only been at it for a year+. I've never heard the term "Bias turned" could you explain the process a little?

Looks like you start with a rectangular solid and leave some of the flat faces on.

Thanks,

Dave

Re: Bias turned

#3

Re: Bias turned

RevDoug

>Dave, easier than that. Started with a cube. Two of the opposite corners were cut off to give me a flat spot for the two centers to take hold of the blank. Tailstock end will become the bottom, headstock the top of the bowl. Turn the bottom half down to the point you want to stop, pretty close to what you want your final shape to be. Turn a tenon for your chuck as well. Reverse the blank, mounting the tenon in your chuck and bring up the tailstock (for safty). Turn the entire outside to your finished shape and begin the hollowing. Do as much of the hollowing as you can with the tailstock in place. Once you've gone as far as you can, remove the tailstock and finish the hollowing of the piece as normal.

Safty Note: You will want to be very careful with the "tips" that emerge. They will bite you.

Finish the turning, sand and finish. You're done. Can also be done with a cylinder which leaves a large lip out to one side. Good luck and have fun.

Turn 'em round,

Re: Bias turned

#4

Re: Bias turned

Lan Brady

>Doug,

If you turn it more shallow, you can get two rocking bowls from a cube.

If you do not seperate the two bowls, the bottom part makes 3 foots(feet?) for the other side. The best part is, the legs are 60 degrees off from the top points. interesting look!

Lan

Re: Bias turned

#5

Re: Bias turned

RevDoug

>Lan, exactely. There are so many possibilities with this kind of turning. This was a first for me and was done for a challenge and trade on another board. I can see a whole series coming out of this. Opposite ended bowls, bowl with feet, a smoother bowl, a squarer bowl, longer points, shorter points. The variations go on and on. This thought can be fun.

Turn 'em round,