Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Rats!!!!

Posts

Rats!!!!

#1

Rats!!!!

Don Henthorn

>Finally turned and finished the maple blank that Carole sent me months ago. Really spent some time and effort on the finish and it looks really Good. Parted it off the glue blank and used a doughnut chuck to finish the bottom and that went well too. I was really excited about taking it in for the wife to see. Unscrewed the nuts holding the doughnut chuck together and lifted the top half off the turning. I picked up the turning and turned to go in the house and the really glasslike surface of the turning slipped out of my hand and the turning went flying across the room and landed on the concrete floor of my shop. Now the concrete floor was poured by a guy who had his friends over to help with the pour and he had a keg of beer out so the guys could help themselves. The surface of the concrete is about the consistancy of 08 grit sandpaper. Yikes! The part of the bowl that hit first is a disaster. Will have to completely refinish the outside since I used about 8 coats of wiping poly on it. Luckily I turned a foot on the bottom so I think I can use a scroll chuck to hold it while resanding and refinishing the outside. I hate it when something like this happens but I am getting really butterfingered in my dodderring atate.

Re: Rats!!!!

#2

Re: Rats!!!!

tek-Brunswick, Ohio

>If it's dented put a damp rag over the dented area and heat it up with a steam iron, set on the steam setting. That pops out a lot of dents in wood. You will still have to sand and refinish but you might not have to sand as much.

Tom

Re: Rats!!!!

#3

Awwwwman!!! Sorry!!

Blake Washburn

>I'm sorry that happened! I had and experience like that onece. I was carrying a spalted maple bowl to show my dad and I dropped the sun of a gun. A big ol' chip came out of the rim though. I was very disapointed. At least you have the opportunity to refinish the bowl!!

Blake Washburn

:-)

Re: Rats!!!!

#4

Re: Rats!!!!

Carole Valentine

>Aw Don...that's too bad! I know you can fix it but that doesn't make you feel any better, I'm sure. Did you really only say "Rats!"??? ;)

I had that happen a couple of time on the buffing wheel. I also have a concrete floor and believe me, I did NOT say "rats!" LOL

Re: Rats!!!!

#5

Ellis Walentine

If it's any consolation...

Ellis Walentine

>...I was leaving the shop one dark night about midnight after just finishing the nicest natural-edged honeylocust pot I've ever done. Little did I know that my wife's car was parked right in my path. In the pitch dark I didn't see it, and -- you can guess the rest -- I walked right into the back of her car with this lovely turning in my hands. It practically exploded when it hit the blacktop.

I've found that we (speaking for myself) make fewer turning mistakes as we gain experience, but we can't outrun Murphy's Law.

Sorry for your incident. I think we all feel your pain.

Ellis