Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

drilling dear antler (again)

Posts

drilling dear antler (again)

#1

drilling dear antler (again)

Blake Washburn

>I still want to know the process of drilling deerantler. I want somebody to please give me step by step instructions on how to drill deerantler!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Blake Washburn

:-)

Re: drilling dear antler (again)

#2

Re: drilling dear antler (again)

Dave Bonde - Iowa

>I drill antler using a bradpiont bit and an electric hand drill. I cut the antler into sections a little longer than the finished length, put it in a vise and site by eye the path I want the drill bit to follow (if the antler section has any curve to it)and drill. The chips do not flow very well in antler so you need to back the bit out more often to clean out the chips. I miss every once in a while but for the most part the process works well. I then glue in the pen tube (I make pens with them) and sruare the ends on the disc sander using a jig that squares the blank to the tube. Its not a fancy process but works for me. Dave

Re: drilling dear antler (again)

#3

THANK YOU DAVE!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Blake Washburn

>

Re: drilling dear antler (again)

#4

Re: drilling dear antler (again)

Ken Grunke from SW WI

>It usually helps to poke a little starter hole first, with a pointed tool like an awl, a drywall screw, nail, or, of all things, a center punch and light hammer.

Then it might be a good idea to ues a small drill first, to drill a pilot hole which helps guide the final size drill bit.

If drilling something small with a portable drill, hold it with a vise or c-clamp to the edge of a bench. I find it more comfortable to drill horizontally, "shooting from the hip".

Antler's kinda stinky, isn't it? Whatchya makin', Blake?

Re: drilling dear antler (again)

#5

Re: drilling dear antler (again)

eaglesc

>I drill antler on the DP and the lathe regularly.

The trick in drilling on the DP is getting one side at a right angle to put in the vice.(or at tleast straight)

To drill on the lathe turn it round betwen centers and use a collet chuck though I imagine a scroll chuck would work also.

If this is not what you are having problems with, specifically, what are you having problems with?

(modified perfect fit with mule deer)


img

Re: drilling dear antler (again)

#6

Re: drilling dear antler (again)

ChuckS

>How I drill antler:

Cut a little long, align between centers, and turn to round (at least enough to chuck in next step).

Chuck in scroll jaws, and drill on lathe.

I drill it wet, antler is nasty & you really, really don't want to breathe it. Keep backing out the bit to remove chips/dust/slurry.

Smile!

ChuckS