Anyone turned cypress?
OB OBrien In Pensacola
>Have just taken on a job to turn 25 spindles 24 inches long out of cypress. Any one have any words of wisdom? Thanks in advance. OB
Knowledge You Can Build On — Est. 1998
Anyone turned cypress?
OB OBrien In Pensacola
>Have just taken on a job to turn 25 spindles 24 inches long out of cypress. Any one have any words of wisdom? Thanks in advance. OB
Re: Anyone turned cypress?
Danny Wells
>Very, very sharp tools and good sand paper. Hope you're charging enough for the job. I've tried several pieces and it was always a pain in the butt. Tears our badly no matter how sharp the tools. Then it's a pain to sand because of the great difference in density between the summer wood and winter wood. I just quit turning it. It the wood happens to be very, very tight grained (close growth rings), it might not be quite as bad.
I don't mean to rain on your parade, but that's been my experience.
Re: Anyone turned cypress?
Bill in Ga
>I have turned some leyland cypress and it turns very well
both dry and wet. It looks something like norfolk island pine wood.
Re: Anyone turned cypress?
Keith Newton
>Danny, I am sorry to contradict your Summer / Winter statement. I know most people don't like to be corrected, but in the softwoods that are soft / hard transition, the soft is Spring or early-wood, and the dense is Summer into fall. Otherwise known as Latewood.
In Ring-porous trees, the open porous portion of the annual ring is the Spring, or Early-wood, and the dense portion is summer or latewood. There may be exceptions, but most trees are dormant during the cold months throughout the temperate zones.
Re: Anyone turned cypress?
OB OBrien In Pensacola
>Thanks folks; I get delivery of the kiln dried blanks next week. will let you know how it turns out.