Candle holder.Honey-locust-copper and quarts
Leo Van Der Loo
>I have some hard rock core samples and have been trying to make good use of them, this is one example of what I came up with.
Have fun and take care
Leo Van Der Loo
Knowledge You Can Build On — Est. 1998
Candle holder.Honey-locust-copper and quarts
Leo Van Der Loo
>I have some hard rock core samples and have been trying to make good use of them, this is one example of what I came up with.
Have fun and take care
Leo Van Der Loo
Candle holder back side
Leo Van Der Loo
>
Candle holder top
Leo Van Der Loo
>
Candle holder foot
Leo Van Der Loo
>
Candle holder bottom
Leo Van Der Loo
>
Grenville?
Jim Shaver - Oakville, Ontario
>
Re: Grenville?
Leo Van Der Loo
>Jim, from an old graphite and mica mine in the wilds of NE Ontario,
4 wheel drive ATV and hours of logging road travel to get there.
there was a road out of there at one time, 60+ years ago.
It,s beautiful up there, A buddy and I found a whole pile off it, and we took some along, mine's been abandoned since WWII.
Have fun and take care
Leo Van Der Loo
Re: Grenville!
Jim Shaver - Oakville, Ontario
>Classic Grenville has graphite found in it, usually in granites and gneisses from the region close to the contact with the Superiour...
:-)
Good for you! 1.8 Billion Years old
take care,
jim
Re: Grenville!
Leo Van Der Loo
>OK Jim, something new I learned, thanks.
I thought you where thinking it came from Grenville, halfway between Ottawa and the 401.
there are mica mines in that area, mostly small and worked out.
Have fun and take care
Leo Van Der Loo
Re: Candle holder.Honey-locust-copper and quarts
Bill Hale
>Leo
This is neat. Where did you get the copper. AZ. is the copper state and I like to do copper, turquoise and mesquite stuff.
Good turning and be safe
Bill in Casa Grande, AZ.
Re: Candle holder.Honey-locust-copper and quarts
Steve in NC
>Leo
Very nice job. I am a soils engineer and have lots of rock core. I keep a few nice pieces but most of it gets tossed because I have not been able to think of a good use.
I have access to a diamond wet saw and have tried cutting a few disks to insert into boxes but your candle stick shows some new possiblities.
Where did you get the copper base.
Again, nice job.
Steve
more info please
Doug Littlejohn
>Now I see what I could do with the box full of core rods I have !! One question though, how did you polish up the core sample rod??
TIA,
Sherwood
More info candleholder
Leo Van Der Loo
>The copper cup and dish I spun on my lathe, the dish is made from copper sheet and the cup from copper pipe, the core I sanded as good as I could with silicon carbide sand paper, I have no diamond grit or abrasives, then polished with white diamond then applied CA and polished the CA, then epoxied all together.
http://homepage.mac.com/l.vanderloo/PhotoAlbum4.html
Have fun and take care
Leo Van Der Loo
Re: more info please
Steve in NC
>I saw cut the ends of the core square. I wrap some tape around one end and put it in my chuck. Use a cone on the tailstock. Polish with wet/dry paper. I use Krylon spray to finish. Use several coats and wet sand between each.
Leo has inspired me. I have large amounts of this stuff. I will give it a try and post some results.
Steve