Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Adding ballast to Jet mini stand

Posts

Adding ballast to Jet mini stand

#1

Adding ballast to Jet mini stand

Mark Wollschlager

>I have a jet mini with the jet stand.

It is steady as a rock but when a peice is a bit out of round there is a bit of vibration. On my other lathe there is a shelf that I have loaded with cast iron, cement, etc.

I have been experimenting with attaching some cast iron plate pieces to the jet mini. Zip tie attached to the center support at this point.

Before I drill, should they be higher or lower than the center support?

Or, is this type of stand just going to vibrate.

I can usually find a speed that vibrates less until I get things round, but a bit of dampening might help.

thanks,

Mark.

Re: Adding ballast to Jet mini stand

#2

Better to use sand

Dominic Greco in Richboro PA

>Mark,

I would recommend using sand bags on the shelf rather than iron weights. Back when I had my old Jet 1236 I used cast iron weights and they made a heck of a lot of noise even with some padding between them. Then I switched to 50lb bags of play sand that I bought at Home Depot for $2.25/each. This made a WORLD of difference.

While this doesn't exactly answer your question, I hope it helps.

See ya around,

Dominic

Re: Adding ballast to Jet mini stand

#3

Re: Better to use sand

John Lucas

>Mark I would make a box A frame shaped to run from the bottom of the lathe to the feet and then fill it with sand or Pea Gravel. I went with pea gravel because it doesn't leak out as easily.

Re: Adding ballast to Jet mini stand

#4

Re: Adding ballast to Jet mini stand

Pete in Holland, MI

>Cast iron is mass that needs more energy to get moving, thus reducing machine vibration. Sand, on the other hand, is heavy like cast iron, but is "fluid" and absorbs the vibration by slight movement between the sand crystals. I have bags of pea stone in a box on my Jet 1236.

Your stand, if I recall, has 2 square tubes coming up from the base. These, no mater what mass you use, will wobble. May want to try a brace along with the sand bags.