We value your privacy.
We use cookies to enhance your browsing experience, analyse site traffic, and personalise content.
By clicking “Accept all”, you consent to our use of cookies. You can also choose
“Essential only” or learn more.
>I just finished a 12" bowl out of cedar. What is a good finish to use on Cedar? Is there any special prep work necessary, other than sanding or course, prior to putting the finish on cedar? It is probably 50% sapwood and 50% heartwood.
>I like several coats of Danish Oil. 7 - 10 coats rubbed out with steel wool once each coat drys makes for a fine finish that is in the wood not on the surface.
>Bob, I have seen a lot of answers to this question in the past on WC. I recall things about clear finishes, smell, etc. Do a search in the Turning Archive, and I'm sure you will find a lot of good advice. ...Gary
>I have used Danish oil on some cedar christmas ornaments. It will take many coats. The end grain will suck-up the oil, but just keep applying and wipe off the excess each time. It will take some time to let each coat dry before the next one.
I am sure multiple coats of any of your favorite finish will work.
>Somebody posted a message a few months ago - maybe even over the summer with a gorgeous cedar bowl they had turned. That person finished with Beeswax, but it was cut with something I no longer remember. I recently turned one and used beeswax by itself. Quite pleased with the finish. Buttery soft too.
>If you're not simply interested in retaining the smell of the cedar, try this: (I adapted it from a posting by Carole Valentine.)
I mix about 40% lacquer and 60% lacquer thinner. Turn the lathe on slow. Apply the mixture with a soft cloth (ladie's shoulder pad works really well), followed immediately with a clean, dry, lintless, cloth. Buff 'til dry. Let set for a while to thoroughly dry. Apply beeswax. Melt it in by buffing. It's a gorgeous, soft finish.
Thanks, Carole V. I've learned a ton from you and others on this forum.