Re: new tool on the market
RussFairfield
>We use a scraper without the tool-rest, and with or without the lathe running for several reasons; and we don't have to be a big name woodturner or have a special tool to do it.
We would use a scraper without the tool-rest for all of the same reasons that we would use sandpaper or a scraper on a piece of furniture - to make the lightest cut possible on the surface of the wood. We would choose the scraper because we can remove more wood faster than with sandpaper, it leaves a better finish on the wood, and there is little to no rounding of sharp corners.
Using a scraper without the tool-rest can make the lightest cut possible with a steel tool on a piece of wood. Warping in of no consequense when the lathe is running because the tool is following the wood without any restrictions from the tool-rest. It is impossible to get a "catch". Overhang beyond the tool rest is not a concern when there is no tool-rest.
If the lathe is ON, a small amount of wood can be removed around the entire piece; or a small amount of wood or torn grain can be removed from a small area when the lathe is OFF.
Lathe speed is not a factor, and it cuts equally as well whether we are passing the wood across the scraper, or the scraper across the wood.
Either a cabinet scraper, or the tool we call a scrper can be used. They are the same tool, and they cut with or without the same burr. The burr on the woodturning scraper lasts longer because its steel is harder. If the lathe is running, the woodturning scraper doesn't get as hot as fast because of its greater mass and that there is a handle to hold. It is also less likely to chatter because it is heavier.