Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Cutting Bowl/Urn Segments

Posts

Cutting Bowl/Urn Segments

#1

Cutting Bowl/Urn Segments

David Lykins - Marietta GA - guitardude

>I'm in the process of making an Pet Urn for my roomates dog. I downloaded the trial version of Woodturner Pro, what a cool program for segmented turnings. This is my first attempt at making a segmented piece.

Anyway, I've got all the segments calculated by the software and I was wonder what is the best way to cut these segments?

I've cut one segment out of some scrap by cutting off one end at the specific angle (in this case everything is 15 degrees) and then make a stop and set it for the specific length of the outer edge, like 1-29/32" to cut it exact. My second attempt came out great and I glued up the pieces to make sure I that it came out OK after the glueup.

Any help is greatly appreciated.

Thanks

Re: Cutting Bowl/Urn Segments

#2

Re: Cutting Bowl/Urn Segments *LINK*

georgetroy

>First off I will give you my segmented web site. It has basics instructions. You can cut segments with table saw, miter saw, radial arm saw and bandsaw. A disc sander will sand the pieces, a jig is great help here. I gather you have a plan to go by. Besure you lay up in brick fashion and round the bottom inside before you get too many rings lined up. You need to list what equipment you have and how you will go about making the rings flat. GT


Segmented Wood turner

Re: Cutting Bowl/Urn Segments

#3

Re: Cutting Bowl/Urn Segments *LINK*

Ron in Drums PA

>Great Book, Malcolm tells it all.


http://www.tahoeturner.com/book.html

Re: Cutting Bowl/Urn Segments

#4

Help George, site problem

David Lykins - Marietta GA - guitardude

>Thanks for the url, however it goes to the following site:

http://www.georgetroygraphics.com/

I didn't see anything on Bowl Turning, did I miss something?

Any help is greatly appreciated.

Thanks.

Re: Cutting Bowl/Urn Segments

#5

Re: Cutting Bowl/Urn Segments

David Lykins - Marietta GA - guitardude

>WOW! That guy is absolutely amazing, thanks for the site Ron.