Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Floor stands for banjos/tool rests

Posts

Floor stands for banjos/tool rests

#1

Floor stands for banjos/tool rests

Chris K in MD

>I was wondering if there are any of you out there that have experiance with stands to turn off board of your lathe and satandard banjo setup. Powermatic offers one for 3520A, I think the lower set of holes to mount the 18" bed on the 3520B renders this item not likely required. I Have seen some pictures of people with thier outboard stands, but dont know where they bought them and If there pleased with them. Thank you for any info that you have.

Regards,

Chris

Re: Floor stands for banjos/tool rests

#2

Re: Floor stands for banjos/tool rests

georgetroy

>Outboard stand that are independent of the lathe are not safe. From my personal experience I broke a Delta Cast Iron tool rest on one. Granted it was a 50 lb. block of wood. The least little tilt can cause a crash & burn and endanger your body. I do use an outboard stand by Vicmarc. It is bolted to the lathe and the post sets on the floor. Cost about $295 and well worth it. Don't even think about making your own out of an old steel wheel, a post and concrete. Of course this is my baised opinion.

Re: Floor stands for banjos/tool rests

#3

Re: Floor stands for banjos/tool rests

bob davis

>for what it is worth i fully agree