Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Jet anchoring down

Posts

Jet anchoring down

#1

Jet anchoring down

TheHeretic

>Quick question for those with the Jet Mini Lathe. I dont have the legs for the Jet. But I was going to just bolt it to the table. For the most part I do only small stuff but am also doing about 6-10 larger items. Was just wondering if anyone does just bolt it down. OR should I wait and wait and get a larger lathe?

The bench that it will go to is around 250 lbs and could be more.

Dean

Columbus OH

Re: Jet anchoring down

#2

Re: Jet anchoring down

Ron McKinley

>Mine is bolted to a workbench. I originally built the workbench lower than normal since I planned it as an assembly bench for flatwork. Turned out it was the right height for the Jet Midi.

The Jet ran so smooth I didn't initially bolt it down but then I began to "find" some wood for larger bowls and it does need to be bolted down with unblanced loads.

Re: Jet anchoring down

#3

Re: Jet anchoring down

Barry Turner

>You can bolt it down if you like, but it may not be necessary. I've never bolted mine to the bench and have had no problems. I've turned up to 9 1/4" bowls, (dry wood, not green). As long as you rough larger items at lower speeds, I doubt you will have any problems.

Re: Jet anchoring down

#4

Re: Jet anchoring down

Bill Hale

>Mine sits on top of a roll around tool chest, not bolted. I keep all my small tools, pen stuff, etc in the drawers.

Works great and easy to move out of the way when not in use.

Good turning and be safe

Bill in Casa Grande, AZ.

Re: Jet anchoring down

#5

Re: Jet anchoring down

Mark Wollschlager

>I have the Jet ministatnd legs and like them. T

he woodturning club I belong to has a bunch of Jet minis on work-mate portable 'benches' they work great too. A lot of clubs use them for offsite demos too.

mark.

Re: Jet anchoring down

#6

Re: Jet anchoring down

georgetroy

>Our club has two Jet Mini's and they just use clamps over on a rolling stand. Work's well, I just used one last Saturday. Another thing and you may not want to hear it. I used my own forged steel tool rest. I refuse to use any lathe with a cast iron tool rest. Too many cast iron tool rests will break in due time. Some are even cracked out of the factory. GT

Re: Jet anchoring down

#7

Where did you get the rest?

Bob Fawcett

>

Re: Jet anchoring down

#8

Re: Jet anchoring down

JimQ

>This is what I built for my Delta Midi, which is about the same as the Jet Mini. The top is a 6" long piece of 5X15" GluLam construction beam. It can sure absorb a lot of vibration. The legs are 2X6's.

JimQ


img

Re: Jet anchoring down

#9

Re: Jet anchoring down *LINK*

georgetroy

>You can get a modular tool rest from Craft Supplies. You will need a 5/8" post and your choice of the 3/4" round bar for it. Better safe than sorry on getting a tool rest that won't snap. I broke a Delta cast iron tool rest a few years ago and it scared the heck out of me. Showing link for the Tool rest section. GT


Modular Tool Rest

Re: Jet anchoring down

#10

Re: Jet anchoring down

Don Henthorn

>Why do I get Microsoft with that link?