Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Negative Rake Scraper Angle

Posts

Negative Rake Scraper Angle

#1

Negative Rake Scraper Angle

Greg in Oshkosh

>Thanks for all the answers in my origional post below. I now know what to call it but I would like to know what angle to sharpen the scraper to. I've been told that the top and bottom angles are the same and that they meet below center so that the top bevel is longer. But what angle??

Re: Negative Rake Scraper Angle

#2

Re: Negative Rake Scraper Angle

Greg in Oshkosh

>This would also be a great opportunity for a picture in the tool grinds library

Re: Negative Rake Scraper Angle

#3

Re: Negative Rake Scraper Angle

Wally Dickerman in Arizona

>I grind my scrapers at 60 degrees....or 30 degrees, which ever way you measure it.

Wally

Re: Negative Rake Scraper Angle

#4

Above center

Craig Daymon

>All the ones I have seen are ground to meet above center. The top is ground only a fraction of what the bottom is ground. I think the thought is that you want to keep the bulk of the tool steel below the cutting edge, but you are grinding away a slight bevel on the top to avoid a potential catch.

I watched a club member on Tuesday, demoing thin turning, use one on the inside of a 12" bowl with less than a 1/8" wall thickness. (He didn't finish the bowl, that was just where he stopped. We'll see it next month. GREAT demo!)

-Craig

Re: Negative Rake Scraper Angle

#5

Re: Negative Rake Scraper Angle

Dick Anderson

>A skew chisel when used as a scraper is a negative rake scraper. The skew that I use specifically as a negative rake scraper is ground at 40-degrees with equal bevels on both sides just like a regular skew. However, since the negative rake scraper is used only for the final smoothing cut and it is the burr on the top edge that does the cutting you will be grinding frequently. The burr will last about 5-seconds on a hard wood. With frequent grindings of the skew (negative rake scraper) to produce a burr you will end up with a short bevel and a long bevel. It doesn't affect the negative scrape action in my opinion. I also have a designed negative rake scraper that is radiused. The top bevel is about 30-degrees off horizontal and is long. The bottom bevel is about 40-degrees off horizontal and is short, because that is the surface that will be ground for creating the burr on top. As you sharpen then the top bevel is shortened and the bottom bevel is lengthened. Upshot is that the length of the two bevels doesn't make too much difference. I will stay with the normal angle I sharpen my skew chisels for the negative rake scraper. I hope this helps.