Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Powermatic height

Posts

Powermatic height

#1

Powermatic height

Jim K in Trappe PA

>I'm thinking of getting a new lathe. I've read good things about Powermatics, and saw one recently and it seemed so much taller than anything else, which could be an ergonomic problem. Is this just me? Is the height adjustable? Does it matter?

Thanks.

Re: Powermatic height

#2

Re: Powermatic height

Cody Carse

>I think the general guideline that everyone goes by is having the height of the spindle at about your elbow height when your arm is down at your side.

Re: Powermatic height

#3

Re: Powermatic height

Joel Hunnicutt

>It is height adjustable, but up and not down, via screw foot pads. I actaully found it to be a bit low. I am 6 ft. and I set my lathe up on 2x4 blocks.

Re: Powermatic height

#4

Re: Powermatic height

John Lucas

>Jim It's only one size, it does have adjustable feet for leveling but if you screw them up very far you get excessive vibration. I'm 5'6" and like my lathe a little above elbow height. It's just a hair tall for me with the feet screwed all the way down.

Re: Powermatic height

#5

Re: Powermatic height

Chris K in MD

>John,

Do you have a ballast box? I am 6' and have the pads all the way up. With 300 lbs of lead in the ballast box I havent been able to get it to wiggle.

- Chris

Re: Powermatic height

#6

Re: Powermatic height *LINK*

Kurt From Jersey

>This would raise it up some and make it portable also! I found this while surfing and it looks nice and sturdy. I wonder how stable it is! It would be cool to be able to rool the lathe outside on nice spring days!I'm 6'2" and will most likey need to raise mine somehow.


Mobile base

Re: Powermatic height

#7

Re: Powermatic height

John Lucas

>Chris I have 300 lbs of rock sitting on a shelf on the lathe. It will still vibrate when I'm turning out of balance stuff even with the feet all the way down. I may be spinning this stuff too fast but sometimes I just gotta.:)

Re: Powermatic height

#8

Thanks all!

Jim K in Trappe PA

>