Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Hollowing tool profiles ?

Posts

Hollowing tool profiles ?

#1

Hollowing tool profiles ?

tek-Brunswick, Ohio

>I bought a used Dennis Stewart arm brace tool. It had the holder for the 3/16 cutters with it, but no cutters. I picked up some 3/16 high-speed steel cutters at a local machinist supply house. If you look down from the top of the cutter what profile do you grind on yours and why? I have the Sorby MultiTip tool. Its 3/16 half round cutters come in two profiles, one shaped like a miniature curved bowl scraper and one with two flat bevels intersecting to form a corner. I bought 10 - 3/16 x 3/16 x 2 � cutters for $1 each. I figure I can cut each one in two with a cutoff wheel, so that would give me 10 bits so I can have a variety of shapes if needed. I do have the tear drop scraper that I can clean up with.

Tom

Re: Hollowing tool profiles ?

#2

Re: Hollowing tool profiles ?

John Lucas

>Tom I don't know about everyone else but I grind mine so the nose looks like my bowl gouge.

Re: Hollowing tool profiles ?

#3

Re: Thanks John

tek-Brunswick, Ohio

>

Re: Hollowing tool profiles ?

#4

Re: 180 degrees of 3/32 radius.

Al Crandall (NE of Indy)

>My hollowing tools all have a full radius on the end. I set the large tool rest plate of the Wolverine at 15 degrees of relief angle and pivot the 3/16 bit a full half circle while it is flat on the rest. This allows me to make agressive cuts depth wise, feeding toward or away from center, no matter if the tool is mounted in a 45 degree hole or a straight hole in the boring bar.

This profile is safely ground if you have a tool rest plate which is notched to allow it to fit around the grinding wheel and up the sides slightly so that it fully supports a narrow tool bit at the extreme ends of the pivoting motion.

Re: Hollowing tool profiles ?

#5

Re:Thanks

tek-Brunswick, Ohio

>I'll try one like that. It makes pretty goood sense to me.

Tom