Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

V groove router bit

Posts

V groove router bit

#1

V groove router bit

John Lucas

>I posted this on the flat side as well. I have been trying to put inlay's in my turning using a V groove router bit. It turns out these aren't 90 degrees between the edges. Both that I have are about 87 degrees. This won't work for me. Does anyone know of a bit that is truely 90 degrees. I have a freud and an offbrand.

Re: V groove router bit

#2

Re: V groove router bit

Bob Fawcett

>I have never turned anything so this may be a crazy idea. If you took a regular straight bit you could angle the router motor to get a 90 degree V. If clearance is a problem maybe a small laminate type router motor would provide it.

Re: V groove router bit

#3

Re: V groove router bit

John Lucas

>Bob I actually have that planned since my Trim router has a base that will let me adjust the angle. I just haven't been able to get the materials to build the base.

Re: V groove router bit

#6

Re: Whiteside makes one

John Lucas

>Thanks I'll check out those sources also. I want someone to check them and make sure they are 90 degrees not some angle close. I also found them in Highland Hardware. They like thiers about twice as much as Eagle American likes thiers, if you know what I mean.

Re: V groove router bit

#7

WoodCraft carries them as well.

RevDoug

>

Re: V groove router bit

#8

Re: V groove router bit

Bill Stehman

>John,

It is obvious you have checked the angle to your bits, I used to do a lot of diamonds between segments similar to your method and found the stops to my table saw for cutting the inlays contaminated every now and then. As the bits wore in time I would tilt my blade ever so much to compensate for a tight fit... food for thought. Always leave just a slight lose fit for glue but you know that... 1/2 cents worth... chuckle.

Re: V groove router bit

#9

Re: Check your email, John

Allen Neighbors

>

Re: V groove router bit

#10

Re: V groove router bit

John Lucas

>Bill Good idea. I should have known I wasn't re-inventing the wheel.