Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Powermatic 3520 A question

Posts

Powermatic 3520 A question

#1

Powermatic 3520 A question

ken chase

>The lever in front of the motor on the operators side that locks the headstock in position is loose and I can't figure out how to adjust it.

There is a slotted screw at it's center but I could not get it to turn.

A call to Powermatic was a waste of time. Help will be greatly appreciated. Thanks

Re: Powermatic 3520 A question

#2

Re: Powermatic 3520 A question

rabbit

>Ken

The lever that locks the headstock down is on the opposite of where the operator would stand. At least on mine it is. It sounds like your describing the motor lock down. You would loosen this to adjust you speed ratio's.

Look for a long handle on the backside.

Re: Powermatic 3520 A question

#3

Ditto

DougJ in Crawfordsville, IN

>

Re: Powermatic 3520 A question

#4

Re: Ditto

John Lucas

>The lever you are desribing has a slotted screw in the end. All this does is hold in the spring that keeps the lever in place. The lever can be moved to other positions by pulling it straight out toward the slotted screw. Then you loosen this lever by moving it CCW to loosen the motor so that you can adjust the belts.

The big lever on the back under the controller is what lets you slide the entire headstock along the lathe.