Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Looks like the Jet Mini, now wood?

Posts

Looks like the Jet Mini, now wood?

#1

Looks like the Jet Mini, now wood?

Bob Fawcett

>Looks like most agree that the Jet Mini lathe is the one to start on. Which wood would be best to learn on? I have mahogany, cherry, walnut, maple, and pine in the shop now. I also have some turning squares of Gonzalo Alves and Bubinga, but don't limit to these.

Re: Looks like the Jet Mini, now wood?

#2

Re: Looks like the Jet Mini, now wood?

Norm Smith in Nova Scotia

>Try using free wet wood for a few days. You will learn a lot.

Norm

Re: Looks like the Jet Mini, now wood?

#3

Re: Looks like the Jet Mini, now wood?

John K Jordan

>Any of these will work, but when I started I wanted to save the more expensive and better figured wood until I got some experience. (I have some big slabs of cocobolo that I don't think I'll EVER feel "qualified" to turn!)

Many people like to turn green wood - it cuts far easier than dry wood and is often inexpensive or free. Some freshly cut firewood will work fine. There is an excellent book "Turning Green Wood" that is full of good ideas and instruction.

JKJ

Re: Looks like the Jet Mini, now wood?

#4

Re: Looks like the Jet Mini, now wood? *LINK*

tek-Brunswick, Ohio

>You stated in your earlier post that you were interested in spindle turning. I would use pine or fir 2x2s or 4x4s sold for construction lumber to practice technique on. Softwoods cut well with sharp tools and good technique. They tear out with dull tools and scraping technique. When you start doing well on pine, try cherry. It turns very well and you can develop the feel for working in harder woods. You will find more people interested in bowls and hollow forms here than spindle turning, but there are some very good spindle turners in this group. (Keith Tomkins is one of them) Find a local turning club and you can probably find a mentor. And clubs have libraries where you can borrow tapes, books, and DVD�s. I�ve found most turners to be generous with their time and knowledge.

If you get the Jet Mini lathe you will probably want to get the bed extension, so you can turn spindles long enough for furniture. There are also some good used lathes out there. A club would be a good place to find out what is available locally. Here a is a link for the AAW site so you can check on local clubs.

Tom


http://www.woodturner.org/

Re: Looks like the Jet Mini, now wood?

#5

Re: Looks like the Jet Mini, now wood?

Bob Fawcett

>Thanks Tom,

I found Low Country Turners in my area (Savannah Ga). I'll try to contact them.