Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

doubled sealed bearings and vacuum chuck

Posts

doubled sealed bearings and vacuum chuck

#1

doubled sealed bearings and vacuum chuck

Jeremy

>I have put together a vacuum chuck for the lathe but I can't pull a vacuum better than 7mmHg because too much air leaks through the double sealed bearings. If I seal the area with plastic wrap (lathe not turning) I can get a vacuum of 25-27mmHg so I know the problem is only the bearings. I thought that because they are sealed you wouldn't get air leading. Have I missed something and/or have the correct product?

thanks for your time,

jeremy

Re: doubled sealed bearings and vacuum chuck

#2

Re: doubled sealed bearings and vacuum chuck

Paul in Phoenix, AZ

>Jeremy, you need to get a sealed bearing from an autoparts store. Get one that has about a 2" outside diameter and a 1" inside diameter. I have made a couple of vaccuum adapters like this. ~Paul

Re: doubled sealed bearings and vacuum chuck

#3

Re: doubled sealed bearings and vacuum chuck

Phil Joines

>Try running a round end stick lightly against the seals. Sometimes they aren't seated properly.

Re: doubled sealed bearings and vacuum chuck

#4

Re: doubled sealed bearings and vacuum chuck

tek-Brunswick, Ohio

>Are you sure that they are double sealed on not just shielded bearings?